ATMEGA128RFA1-ZU Atmel, ATMEGA128RFA1-ZU Datasheet - Page 227

• Manufacturer Part Number: ATMEGA128RFA1-ZU
• Description: IC AVR MCU 2.4GHZ XCEIVER 64QFN
• Manufacturer: Atmel
• Series: ATMEGAr

Specifications of ATMEGA128RFA1-ZU

• Frequency: 2.4GHz
• Data Rate - Maximum: 2Mbps
• Modulation Or Protocol: 802.15.4 Zigbee
• Applications: General Purpose
• Power - Output: 3.5dBm
• Sensitivity: -100dBm
• Voltage - Supply: 1.8 V ~ 3.6 V
• Current - Receiving: 12.5mA
• Current - Transmitting: 14.5mA
• Data Interface: PCB, Surface Mount
• Memory Size: 128kB Flash, 4kB EEPROM, 16kB RAM
• Antenna Connector: PCB, Surface Mount
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 64-VFQFN, Exposed Pad
• Rf Ic Case Style: QFN
• No. Of Pins: 64
• Supply Voltage Range: 1.8V To 3.6V
• Operating Temperature Range: -40°C To +85°C
• Svhc: No SVHC (15-Dec-2010)
• Rohs Compliant: Yes
• Processor Series: ATMEGA128x
• Core: AVR8
• Data Bus Width: 8 bit
• Program Memory Type: Flash
• Program Memory Size: 128 KB
• Data Ram Size: 16 KB
• Interface Type: JTAG
• Maximum Clock Frequency: 16 MHz
• Number Of Programmable I/os: 38
• Number Of Timers: 6
• Operating Supply Voltage: 1.8 V to 3.6 V
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• 3rd Party Development Tools: EWAVR, EWAVR-BL
• Development Tools By Supplier: ATAVR128RFA1-EK1
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

17.2.1 Registers
17.2.2 Definitions
17.3 Timer/Counter Clock Sources
17.4 Counter Unit
8266A-MCU Wireless-12/09
The Timer/Counter (TCNT0) and Output Compare Registers (OCR0A and OCR0B) are
8-bit registers. Interrupt request signals (abbreviated to Int.Req. in the figure) are all
visible in the Timer Interrupt Flag Register (TIFR0). All interrupts are individually
masked with the Timer Interrupt Mask Register (TIMSK0). TIFR0 and TIMSK0 are not
shown in the figure.
The Timer/Counter can be clocked internally, via the prescaler or by an external clock
source on the T0 pin. The Clock Select logic block controls which clock source and
edge the Timer/Counter uses to increment (or decrement) its value. The Timer/Counter
is inactive when no clock source is selected. The output from the Clock Select logic is
referred to as the timer clock (clk
The double buffered Output Compare Registers (OCR0A and OCR0B) are compared
with the Timer/Counter value at all times. The result of the compare can be used by the
Waveform Generator to generate a PWM or variable frequency output on the Output
Compare pins (OC0A and OC0B); see
The Compare Match event will also set the Compare Flag (OCF0A or OCF0B) which
can be used to generate an Output Compare interrupt request.
Many register and bit references in this section are written in general form. A lower case
“n” replaces the Timer/Counter number (in this case 0). A lower case “x” replaces the
Output Compare Unit (in this case Compare Unit A or Compare Unit B). However when
using the register or bit defines in a program, the precise form must be used i.e.,
TCNT0 for accessing Timer/Counter0 counter value and so on.
The definitions in Table 17-1 are also used extensively throughout the document.
Table 17-1. Definitions
The Timer/Counter can be clocked by an internal or an external clock source. The clock
source is selected by the Clock Select logic which is controlled by the Clock Select
(CS02:0) bits located in the Timer/Counter Control Register (TCCR0B). For details on
clock sources and prescaler see
The main part of the 8-bit Timer/Counter is the programmable bi-directional counter
unit. Figure 17-2 shows a block diagram of the counter and its surroundings.
BOTTOM
MAX
TOP
The counter reaches the BOTTOM when it becomes 0x00.
The counter reaches its MAXimum when it becomes 0xFF (decimal 255).
The counter reaches the TOP when it becomes equal to the highest value in
the count sequence. The TOP value can be assigned to be the fixed value
0xFF (MAX) or the value stored in the OCR0A Register. The assignment is
dependent on the mode of operation.
T0
Timer/Counter 0, 1, 3, 4, and 5 Prescaler on page 304
).
"Output Compare Unit" on page 228
ATmega128RFA1
for details.
227