HD64F2638F20J Renesas Electronics America, HD64F2638F20J Datasheet - Page 525

• Manufacturer Part Number: HD64F2638F20J
• Description: IC H8S MCU FLASH 256K 128-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2600r

Specifications of HD64F2638F20J

• Core Processor: H8S/2600
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: CAN, SCI, SmartCard
• Peripherals: Motor Control PWM, POR, PWM, WDT
• Number Of I /o: 72
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 12x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 128-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

H8S/2639, H8S/2638, H8S/2636,
H8S/2630, H8S/2635 Group
13.3.2
In asynchronous mode, characters are sent or received, each preceded by a start bit indicating the
start of communication and stop bits indicating the end of communication. Serial communication
is thus carried out with synchronization established on a character-by-character basis.
Inside the SCI, the transmitter and receiver are independent units, enabling full-duplex
communication. Both the transmitter and the receiver also have a double-buffered structure, so
that data can be read or written during transmission or reception, enabling continuous data
transfer.
Figure 13-2 shows the general format for asynchronous serial communication.
In asynchronous serial communication, the transmission line is usually held in the mark state (high
level). The SCI monitors the transmission line, and when it goes to the space state (low level),
recognizes a start bit and starts serial communication.
One serial communication character consists of a start bit (low level), followed by data (in LSB-
first order), a parity bit (high or low level), and finally stop bits (high level).
In asynchronous mode, the SCI performs synchronization at the falling edge of the start bit in
reception. The SCI samples the data on the 8th pulse of a clock with a frequency of 16 times the
length of one bit, so that the transfer data is latched at the center of each bit.
REJ09B0103-0800 Rev. 8.00
May 28, 2010
Serial
data
1
Operation in Asynchronous Mode
Start
bit
1 bit
0
LSB
Figure 13-2 Data Format in Asynchronous Communication
D0
One unit of transfer data (character or frame)
(Example with 8-Bit Data, Parity, Two Stop Bits)
D1
D2
Transmit/receive data
D3
7 or 8 bits
D4
D5
D6
MSB
Section 13 Serial Communication Interface (SCI)
D7
Parity
bit
1 bit,
or none
0/1
Stop bit
1
1 or
2 bits
1
Idle state
(mark state)
1
Page 475 of 1458