AT32UC3L032-D3UR Atmel, AT32UC3L032-D3UR Datasheet - Page 765

• Manufacturer Part Number: AT32UC3L032-D3UR
• Description: MCU AVR32 32KB FLASH 48TLLGA
• Manufacturer: Atmel
• Series: AVR®32 UC3r

Specifications of AT32UC3L032-D3UR

• Core Processor: AVR
• Core Size: 32-Bit
• Speed: 50MHz
• Connectivity: I²C, SPI, UART/USART
• Peripherals: Brown-out Detect/Reset, DMA, PWM, WDT
• Number Of I /o: 36
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: FLASH
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 1.62 V ~ 3.6 V
• Data Converters: A/D 9x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 48-TLLGA
• Processor Series: AT32UC3x
• Core: AVR32
• Data Bus Width: 32 bit
• Data Ram Size: 16 KB
• Interface Type: SPI, TWI, USART
• Maximum Clock Frequency: 50 MHz
• Number Of Programmable I/os: 36
• Number Of Timers: 7
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• 3rd Party Development Tools: EWAVR32, EWAVR32-BL
• Development Tools By Supplier: AT32UC3L-EK
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 10 bit, 9 Channel
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Lead Free Status / Rohs Status: Details

31.6
31.6.1
31.6.2
32099F–11/2010
aWire Debug Interface (AW)
Features
Overview
Rev.: 2.1.0.1
•
•
•
•
•
•
•
•
The aWire Debug Interface (AW) offers a single pin debug solution that is fully compatible with
the functionality offered by the JTAG interface, except boundary scan. This functionality includes
memory access, programming capabilities, and On-Chip Debug access.
Figure 31-8 on page 766
RESET_N pin is used both as reset and debug pin. A special sequence on RESET_N is needed
to block the normal reset functionality and enable the AW.
The Service Access Bus (SAB) interface contains address and data registers for the Service
Access Bus, which gives access to On-Chip Debug, programming, and other functions in the
device. The SAB offers several modes of access to the address and data registers, as dis-
cussed in
Section 31.6.7
description in this document.
If the AW is not used for debugging, the aWire UART can be used by the user to send or receive
data with one stop bit, eight data bits, no parity bits, and one stop bit. This can be controlled
through the aWire user interface.
Single pin debug system.
Half Duplex asynchronous communication (UART compatible).
Full duplex mode for direct UART connection.
Compatible with JTAG functionality, except boundary scan.
Failsafe packet-oriented protocol.
Read and write on-chip memory and program on-chip flash and fuses through SAB interface.
On-Chip Debug access through SAB interface.
Asynchronous receiver or transmitter when the aWire system is not used for debugging.
Section
lists the supported aWire commands and responses, with references to the
31.6.6.8.
shows how the AW is connected in a 32-bit AVR device. The
AT32UC3L016/32/64
765