TMPM382FSFG Toshiba, TMPM382FSFG Datasheet - Page 250

• Manufacturer Part Number: TMPM382FSFG
• Manufacturer: Toshiba

Specifications of TMPM382FSFG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): 64K
• Rom Type: Flash
• Ram (kbytes): 8K
• Number Of Pins: 64
• Package: QFP(14x14)
• Vcc: 5V
• Cpu Mhz: 40
• Ssp (ch) Spi: 1
• I2c/sio (ch): 1
• Uart/sio (ch): 3
• Usb: -
• Can: -
• Ethernet: -
• External Bus Interface: N
• Cs/wait Controller (ch): -
• Dma Controller: 2
• 10-bit Da Converter: -
• 10-bit Ad Converter: -
• 12-bit Ad Converter: 10
• 16-bit Timer / Counter: 6
• Motor / Igbt Control: Y
• Real Time Clock: 1
• Watchdog Timer: Y
• Osc Freq Detect: Y
• Clock Gear: Y
• Low-power Hold Function: -
• Remote Control Interface: Y
• Hardware Cec Controller: -
• Comparators: -
• Low-voltage Detector: Y
• Etm Hardware Trace: 2-bit

10 16-bit Multi-purpose Timers (MPTs)
Counter value
MTnOUT0/1
(Example)
MTOUT00/10
MTnCAP0
MTnCAP1
INTMCAPn0
INTMCAPn1
INTMTTBn0
(MTUC0)
10.6.14 How to start IGBT timer
MT0IGR
MTnIN
(Example)
0
10.6.14.1
start counting. Once the count has reached a specified period, the counter is cleared. The counter
subsequently restarts counting if specifies continuous mode (MT0IGCR<IGSNGL>=0) it stops
counting if specifies one-time mode (MT0IGCR<IGSNGL>=1). Writing “1” to MT0IGRESTA
<IGRESTA> before the count reaches a period causes the counter to be cleared, after which it
operates as specified with <IGSTP[1:0]>.
registers.
MTnIN input both at the rising edge and falling edge are captured by the MTnCPA0 and MTnCAP1
capture register respectively. When the values are captured, INTMTCAPn0 and INTMTCAPn1
generate respectively.
When the counter starts in the command start and trigger capture mode, counter values of
IGBT modes are selected among three starting modes.
Writing “1” to MT0RUN<MTRUN> causes the current count to be cleared and the counter to
The count values at the rising and falling edges on the MT0IN pin can be stored in capture
PPG output with a
period specified with
MTIG0RG4
00
Command start and Trigger capture mode
Count start by
command
00
AA
Figure 10-10 Operation in Capture
Figure 10-9 Operation in Command start
TMPM380/M382 - 50 / 87 -
PPG output with a
period specified with
MTIG0RG4
CC
Count
start
clear
BB
<IGRESTA>=1
Count
clear
DD
PPG output with a
period specified with
MTIG0RG4
Count clear
Restart
TMPM380/M382