TMPM382FSFG Toshiba, TMPM382FSFG Datasheet - Page 53

• Manufacturer Part Number: TMPM382FSFG
• Manufacturer: Toshiba

Specifications of TMPM382FSFG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): 64K
• Rom Type: Flash
• Ram (kbytes): 8K
• Number Of Pins: 64
• Package: QFP(14x14)
• Vcc: 5V
• Cpu Mhz: 40
• Ssp (ch) Spi: 1
• I2c/sio (ch): 1
• Uart/sio (ch): 3
• Usb: -
• Can: -
• Ethernet: -
• External Bus Interface: N
• Cs/wait Controller (ch): -
• Dma Controller: 2
• 10-bit Da Converter: -
• 10-bit Ad Converter: -
• 12-bit Ad Converter: 10
• 16-bit Timer / Counter: 6
• Motor / Igbt Control: Y
• Real Time Clock: 1
• Watchdog Timer: Y
• Osc Freq Detect: Y
• Clock Gear: Y
• Low-power Hold Function: -
• Remote Control Interface: Y
• Hardware Cec Controller: -
• Comparators: -
• Low-voltage Detector: Y
• Etm Hardware Trace: 2-bit

6 Clock/Mode Control
6.5.10 Warm-up
counter is activated automatically. And then the system clock output is started after the elapse of
configured warm-up time. It is necessary to select the oscillator to be used for warm-up in the
CGOSCCR<WUPSEL2:1> and to set the warm-up time in the CGOSCCR<WUODR13:0> before
executing the instruction to enter the STOP/ SLEEP mode.
oscillator to stabilize if the low-speed oscillator is disabled. Enable the low-speed oscillator and then
activate the warm-up by software.
high-speed oscillator and then activate the warm-up.
(Note 1)
(Note 2)
(Note)
Mode transition requires the warm-up so that the oscillator provides stable oscillation.
In the mode transition from STOP to NORMAL/ SLOW or from SLEEP to NORMAL, the warm-up
In the transition from NORMAL to SLOW/ SLEEP, the warm-up is required so that the internal
In the transition from SLOW to NORMAL when the high-speed oscillator is disabled, enable the
Shows whether the warm-up setting of each mode transition is required or not.
In STOP/ SLEEP modes, the PLL is disabled. When returning from these modes,
configure the warm-up time in consideration of the stability time of the PLL and the
oscillator. It takes approx. 200μs for the PLL to be stabilized.
If the low-speed oscillator is disabled, enable the low-speed oscillator and then
activate the warm-up by software.
If the high-speed oscillator is disabled, enable the high-speed oscillator and
then activate the warm-up by software.
NORMAL→IDLE
NORMAL→SLEEP
NORMAL→SLOW
NORMAL→STOP
IDLE→NORMAL
SLEEP→NORMAL
SLEEP→SLOW
SLOW→NORMAL
SLOW→SLEEP
SLOW→STOP
STOP→NORMAL
STOP→SLOW
Mode transition
Table 6-9 Warm-up setting in mode transition
TMPM380/M382 - 22 / 24 -
Warm-up setting
Auto-warm-up
Auto-warm-up
Auto-warm-up
Not required
Not required
Not required
Not required
Not required
Not required
(Note 1)
(Note 1)
(Note 2)
TMPM380/M382