TMPM382FSFG Toshiba, TMPM382FSFG Datasheet - Page 255

• Manufacturer Part Number: TMPM382FSFG
• Manufacturer: Toshiba

Specifications of TMPM382FSFG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): 64K
• Rom Type: Flash
• Ram (kbytes): 8K
• Number Of Pins: 64
• Package: QFP(14x14)
• Vcc: 5V
• Cpu Mhz: 40
• Ssp (ch) Spi: 1
• I2c/sio (ch): 1
• Uart/sio (ch): 3
• Usb: -
• Can: -
• Ethernet: -
• External Bus Interface: N
• Cs/wait Controller (ch): -
• Dma Controller: 2
• 10-bit Da Converter: -
• 10-bit Ad Converter: -
• 12-bit Ad Converter: 10
• 16-bit Timer / Counter: 6
• Motor / Igbt Control: Y
• Real Time Clock: 1
• Watchdog Timer: Y
• Osc Freq Detect: Y
• Clock Gear: Y
• Low-power Hold Function: -
• Remote Control Interface: Y
• Hardware Cec Controller: -
• Comparators: -
• Low-voltage Detector: Y
• Etm Hardware Trace: 2-bit

<IGPOL0>=0
<IGPOL1>=1
MTOUT00
MTOUT10
current period and then stops. If a stop trigger is detected before the end of the period, however, the
counter stops immediately.
10.6.16.3
When MT0IGOCR<IGSTP> is set to “10”, the counter continues counting until the end of the
Registers except MT0IGOCR must not be rewritten before the counter stops completely.
MT0IGST<IGST> can be read to determine whether the counter has stopped.
Note that before changing the timer settings, confirm the counter stopped after period completed.
<IGOEN[1:0]>=11
Enable output
Counting stopped with outputs initialized at the end of the period
Figure 10-15 Stopping the Counter at the End of the Period (<IGSTP>=10)
Start counting
<MTRUN>=1
<IGSTP[1:0]>=10
TMPM380/M382 - 55 / 87 -
Period
Stop command
<MTRUN>=0
Period
Stop counting
Continue counting until the
end of period.
After
output is initialized
counting
TMPM380/M382
stopped,