TMPM382FSFG Toshiba, TMPM382FSFG Datasheet - Page 47

• Manufacturer Part Number: TMPM382FSFG
• Manufacturer: Toshiba

Specifications of TMPM382FSFG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): 64K
• Rom Type: Flash
• Ram (kbytes): 8K
• Number Of Pins: 64
• Package: QFP(14x14)
• Vcc: 5V
• Cpu Mhz: 40
• Ssp (ch) Spi: 1
• I2c/sio (ch): 1
• Uart/sio (ch): 3
• Usb: -
• Can: -
• Ethernet: -
• External Bus Interface: N
• Cs/wait Controller (ch): -
• Dma Controller: 2
• 10-bit Da Converter: -
• 10-bit Ad Converter: -
• 12-bit Ad Converter: 10
• 16-bit Timer / Counter: 6
• Motor / Igbt Control: Y
• Real Time Clock: 1
• Watchdog Timer: Y
• Osc Freq Detect: Y
• Clock Gear: Y
• Low-power Hold Function: -
• Remote Control Interface: Y
• Hardware Cec Controller: -
• Comparators: -
• Low-voltage Detector: Y
• Etm Hardware Trace: 2-bit

6 Clock/Mode Control
6.5
6.5.1
6.5.2
6.5.3
below.
(Note1)
(Note2)
power consumption mode, specify the mode in the system control register CGSTBYCR<STBY2:0> and
execute the WFI (Wait For Interrupt) instruction. In this case, execute reset or generate the interrupt to
release the mode. Releasing by the interrupt requires settings in advance.
(Note 1)
(Note 2)
high-speed clock stopped.
The SLOW mode reduces power consumption compared to the NORMAL mode.
This mode allows only the following peripheral functions to operate: I/O ports, real-time clock (RTC),
TMRB, MPT(TMRB mode), remote control signal preprocessor (RMC).
clock(fosc1 or fosc2). It is shifted to the NORMAL mode with fosc2(internal high-speed oscillator) after
reset. Also low-speed clock is possible to use.
Two operation modes, NORMAL and SLOW, are available. The features of each mode are described
This mode is to operate the CPU core and the peripheral hardware by using the high-speed
The TMPM380 has three low power consumption modes: IDLE, SLEEP and STOP. To switch to the low
The features of each mode are described as follows.
This mode is to operate the CPU core and the peripheral hardware by using the low-speed clock with
Operation Modes
NORMAL Mode
SLOW Mode
Low Power Consumption Mode
Be sure to stop peripheral functions except for the CPU, RTC, I/O ports, TMRB,
MPT(TMRB mode) and RMC before switching to the SLOW mode.
In the slow mode, be sure not to perform reset using the Application Interrupt and
Reset Control Register<SYSRESETREG> of the Cortex-M3 NVIC register.
Transition to the low power consumption mode by executing the WFE (Wait For
Event) instruction is prohibited as the TMPM380 does not offer any event for
releasing the low power consumption mode.
The TMPM380 does not support the low power consumption mode configured with
the SLEEPDEEP bit in the Cortex-M3 core. Setting the SLEEPDEEP bit of the system
control register is prohibited.
TMPM380/M382 - 16 / 24 -
TMPM380/M382