MPC564MZP66 Freescale Semiconductor, MPC564MZP66 Datasheet - Page 356

• Manufacturer Part Number: MPC564MZP66
• Description: IC MCU 512K FLASH 66MHZ 388-BGA
• Manufacturer: Freescale Semiconductor
• Series: MPC5xxr

Specifications of MPC564MZP66

• Core Processor: PowerPC
• Core Size: 32-Bit
• Speed: 66MHz
• Connectivity: CAN, EBI/EMI, SCI, SPI, UART/USART
• Peripherals: POR, PWM, WDT
• Number Of I /o: 56
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 2.5 V ~ 2.7 V
• Data Converters: A/D 32x10b
• Oscillator Type: External
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 388-BGA
• For Use With: MPC564EVB - KIT EVAL FOR MPC561/562/563/564
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

External Bus Interface
memory to three-state the bus before the bus discharge is initiated. EHTR has a slight performance
reduction impact since it adds a clock gap between some read and write cycles.
9.5.3.1
Pre-discharge mode should be enabled in the following cases:
9.5.3.2
Systems that require pre-discharge operation should include the following steps:
9-16
•
•
•
•
•
•
When external devices can charge the data bus to a higher voltage level than 3.1 volts
And when one or more of the following occurs:
— The MPC561/MPC563 uses write accesses to any external memory
— Data show cycles are enabled
— Instruction show cycles are enabled in code compression mode (MPC562/MPC564 only)
Execute boot sequence
Set EHTR bit in all relevant memory banks during the memory controller initialization phase
(configure ORx, and BRx) if it is required to extend the time between read cycles, and
pre-discharge phase of write cycles.
Set PREDIS_EN in PDMCR2 register
Start to write data to external devices
Operating Conditions
Initialization Sequence
EHTR also adds one idle clock for two consecutive read cycles from
different memory banks.
The pre-disharge will not occur, when using multiple processors with a
common bus accessing an external device, if the processor that initiates a
read is different from the processor that initiated the previous write. Perform
a write to the external device to discharge the external bus, or read a value
of 0x0 from the external device, prior to accessing another MCU on the
same bus.
In the case of code compression program tracking (3rd case above), the
PREDIS_EN bit should only be set when program tracking is not required
since pre-discharge mode overwrites the compression show cycles data. The
user should not set PREDIS_EN bit when program tracking is required on
development system, and set PREDIS_EN bit on the production version.
EHTR can always be set to keep the same system performance during
development, and production phases.
MPC561/MPC563 Reference Manual, Rev. 1.2
NOTE
NOTE
NOTE
Freescale Semiconductor