R88M-W75030T-S1 Omron, R88M-W75030T-S1 Datasheet - Page 179

• Manufacturer Part Number: R88M-W75030T-S1
• Description: SERVO MOTOR 750W 200V
• Manufacturer: Omron

Specifications of R88M-W75030T-S1

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: R88MW75030TS1

System Design and Installation
3-2-5 Wiring for Conformity to EMC Directives
The following conditions must be satisfied in order to conform to the EC Directives.
• The Servo Driver must be mounted in a metal case (control box). (It is not necessary to mount the
• Noise filters and surge absorbers must be inserted in power supply lines.
• Shielded cable must be used for I/O signal cables and encoder cables. (Use tinned soft steel wire.)
• Cables leading out from the control box must be enclosed within metal ducts or conduits with
• Ferrite cores must be installed for cables with braided shields, and the shield must be directly
AC Reactor Connection Example
Servomotor in a metal box.)
blades. (It is not necessary to enclose the 30-cm power cable, encoder cable, or connectors in a
metal duct or conduit.)
grounded to a ground plate.
Power supply
When the wiring conditions provided in this section are satisfied, the wiring will conform
to EMC Directives (EN55011 Class A Group 1 (EMI), EN61000-6-2 (EMS)). These
conditions were stipulated when EMC Directive approval was obtained for the W
Series. They will be affected by the installation and wiring conditions resulting from the
connected devices and wiring when the W Series is built into the system. Therefore,
the entire system must be checked for conformity.
R88D-WNA5@-ML2 to WN04@-ML2
AC Reactor
Servo Driver
L1
L2
DC Reactor Connection Example
R88D-WN05H-ML2 to WN30H-ML2
DC Reactor
Servo Driver
Chapter 3
3-23