R88M-W75030T-S1 Omron, R88M-W75030T-S1 Datasheet - Page 200

• Manufacturer Part Number: R88M-W75030T-S1
• Description: SERVO MOTOR 750W 200V
• Manufacturer: Omron

Specifications of R88M-W75030T-S1

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: R88MW75030TS1

4-2
4-2-1 Turning Power ON and Checking Indicators
■
●
• Check to be sure that the power supply voltage is within the ranges shown below.
●
• The main-circuit power supply inputs (L1/L2 or L1/L2/L3) and the control-circuit power supply inputs
• The Servomotor's red (U), white (V), and blue (W) power lines and the yellow/green ground wire
●
• There should be no load on the Servomotor. (Do not connect to the mechanical system.)
• The power lines at the Servomotor must be securely connected.
●
• The Encoder Cable must be securely connected to the Encoder Connector (CN2) at the Servo
• The Encoder Cable must be securely connected to the Encoder Connector at the Servomotor.
●
• The I/O Signal Cable must be securely connected to the I/O Connector (CN1).
4-4
Operation
(L1C/L2C) must be properly connected to the terminal block.
( ) must be properly connected to the terminal block.
Driver.
Checking Power Supply Voltage
Checking Terminal Block Wiring
Checking the Servomotor
Checking the Encoder Connectors
Checking the I/O Connector
Items to Check Before Turning ON the Power
R88D-WN@L-ML2 (Single-phase 100 V AC input)
R88D-WNA5H-ML2/01H-ML2/02H-ML2/04H-ML2/08H-ML2 (Single-phase 200 V AC input)
R88D-WN05H-ML2/10H-ML2/15H-ML2/20H-ML2/30H-ML2 (Three-phase 200 V AC input)
This section explains the procedure following installation and wiring of the Servomotor
and Servo Driver, to prepare the mechanical system for operation. It explains what you
need to check both before and after turning ON the power. It also explains the setup
procedure required if using a Servomotor with an absolute encoder.
Main-circuit power supply:
Control-circuit power supply: Single-phase 100/115 V AC (85 to 127 V) 50/60 Hz
Main-circuit power supply:
Control-circuit power supply: Single-phase 200/230 V AC (170 to 253 V) 50/60 Hz
Main-circuit power supply:
Control-circuit power supply: Single-phase 200/230 V AC (170 to 253 V) 50/60 Hz
Preparing for Operation
Single-phase 100/115 V AC (85 to 127 V) 50/60 Hz
Single-phase 200/230 V AC (170 to 253 V) 50/60 Hz
Three-phase 200/230 V AC (170 to 253 V) 50/60 Hz
Chapter 4