R88M-W75030T-S1 Omron, R88M-W75030T-S1 Datasheet - Page 345

• Manufacturer Part Number: R88M-W75030T-S1
• Description: SERVO MOTOR 750W 200V
• Manufacturer: Omron

Specifications of R88M-W75030T-S1

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: R88MW75030TS1

Troubleshooting
a.02a
a.02b
a.030
a.040
a.04a
a.041
Display
Parameter check-
sum error 2
System parameter
checksum error 2
Main circuit detec-
tion error
Parameter setting
error 1
Parameter setting
error 2
Dividing pulse out-
put setting error
Error
Occurs when the
control circuit
power supply is
turned ON.
Occurs when the
control circuit
power supply is
turned ON.
Occurs when the
control circuit
power supply is
turned ON or dur-
ing operation.
Occurs when the
control circuit
power supply is
turned ON.
Occurs when the
control circuit
power supply is
turned ON.
Status when
error occurs
• The control voltage drops
• The control circuit power
• The upper limit for the
• The control voltage drops
• The Servo Driver
• Servo Driver is defective. • Replace the Servo
• A value outside of the
• The Servo Driver
• The encoder dividing
to a range of 30 to 60 V
AC.
supply was interrupted
during parameter setting.
number of parameter
writes was exceeded
(e.g., parameters were
changed by the host
device with every scan).
to a range of 30 to 60 V
AC.
EEPROM and peripheral
circuits are defective.
setting range was set in
the parameters.
EEPROM and peripheral
circuits are defective.
pulses set in Pn212 are
out of range or do not
meet the setting condi-
tions.
Cause of error
• Correct the power supply
• A constant was input
• Replace the Servo
• Correct the power supply
• Replace the Servo
• Reset the parameters
• Replace the Servo
• Set an appropriate value
and initialize the parame-
ters.
again after parameter ini-
tialization processing.
Driver.
(Correct the parameter
writing method.)
and initialize the parame-
ters.
Driver.
Driver.
within the setting range.
Driver.
for Pn212.
Countermeasures
Chapter 5
5-13