R88M-W75030T-S1 Omron, R88M-W75030T-S1 Datasheet - Page 187

• Manufacturer Part Number: R88M-W75030T-S1
• Description: SERVO MOTOR 750W 200V
• Manufacturer: Omron

Specifications of R88M-W75030T-S1

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: R88MW75030TS1

System Design and Installation
Note 2. The installation conditions of the power cable and the measurement methods greatly affect
Leakage Breaker Connection Example
■
The OMNUC W Series uses serial encoders, with phase-S signals from the encoder. The phase-S
communications speed is 4 Mbits/s.
In order to improve the encoder's noise resistance, take the following measures for wiring and instal-
lation.
• Always use the specified Encoder Cables.
• If lines are interrupted in the middle, be sure to connect them with connectors, making sure that the
• Do not coil cables. If cables are long and are coiled, mutual induction and inductance will increase
• When installing noise filters for Encoder Cables, use clamp filters. The following table shows the
• Do not place the Encoder Cable in the same duct as Power Cables and Control Cables for brakes,
NEC TOKIN
TDK
cable insulation is not peeled off for more than 50 mm. In addition, always use shielded cable.
and will cause malfunctions. Always use cables fully extended.
recommended clamp filter models.
solenoids, clutches, and valves.
Improving Encoder Cable Noise Resistance
Maker
these values. Use these values only for reference. The values differ by a factor of approxi-
mately 3 between standard breakers and inverter breakers.
AC power
supply side
EMI core
Clamp filter
Name
No-fuse breaker
ESD-SR-25
ZCAT2032-0930
ZCAT3035-1330
ZCAT2035-0930A
Surge absorber
Model
Leakage
breaker
Noise filter
1
2
3
NF
E
4
5
6
Servo Driver
side
Chapter 3
3-31