SAM9G10 Atmel Corporation, SAM9G10 Datasheet - Page 308

• Manufacturer Part Number: SAM9G10
• Manufacturer: Atmel Corporation

Specifications of SAM9G10

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 266 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Ssc: 3
• Sd / Emmc: 1
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: No
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.08 to 1.32
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

25.5.4.3
308
308
Hardware Configuration
Software Configuration
SAM9G35
SAM9G35
16-bit SDRAM on EBI
The following configuration has to be performed:
The Data Bus Width is to be programmed to 16 bits.
The SDRAM initialization sequence is described in the section “SDRAM Device Initialization” in
“SDRAM Controller (SDRAMC)”.
In this case VDDNF can be different from VDDIOM. NAND Flash device can be 3.3V or 1.8V
and wired on D16-D31 data bus. NFD0_ON_D16 is to be set to 1.
• Assign the EBI CS1 to the SDRAM controller by setting the bit EBI_CS1A in the EBI Chip
• Initialize the SDRAM Controller depending on the SDRAM device and system bus frequency.
Select Assignment Register located in the bus matrix memory space.
11053B–ATARM–22-Sep-11
11053B–ATARM–22-Sep-11