SAM9G10 Atmel Corporation, SAM9G10 Datasheet - Page 810

• Manufacturer Part Number: SAM9G10
• Manufacturer: Atmel Corporation

Specifications of SAM9G10

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 266 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Ssc: 3
• Sd / Emmc: 1
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: No
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.08 to 1.32
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

39.7.1.2
Figure 39-4. Fractional Baud Rate Generator
39.7.1.3
810
810
SCK
Reserved
MCK/DIV
SAM9G35
SAM9G35
MCK
Fractional Baud Rate in Asynchronous Mode
Baud Rate in Synchronous Mode or SPI Mode
USCLKS
0
1
2
3
The Baud Rate generator previously defined is subject to the following limitation: the output fre-
quency changes by only integer multiples of the reference frequency. An approach to this
problem is to integrate a fractional N clock generator that has a high resolution. The generator
architecture is modified to obtain Baud Rate changes by a fraction of the reference source clock.
This fractional part is programmed with the FP field in the Baud Rate Generator Register
(US_BRGR). If FP is not 0, the fractional part is activated. The resolution is one eighth of the
clock divider. This feature is only available when using USART normal mode. The fractional
Baud Rate is calculated using the following formula:
The modified architecture is presented below:
If the USART is programmed to operate in synchronous mode, the selected clock is simply
divided by the field CD in US_BRGR.
In synchronous mode, if the external clock is selected (USCLKS = 3), the clock is provided
directly by the signal on the USART SCK pin. No division is active. The value written in
US_BRGR has no effect. The external clock frequency must be at least 4.5 times lower than the
Baudrate
BaudRate
16-bit Counter
CD
=
---------------------------------------------------------------- -
8 2 Over
Modulus
=
Control
FP
SelectedClock
------------------------------------- -
SelectedClock
–
CD
CD
glitch-free
USCLKS = 3
+
logic
FP
------ -
FP
8
SYNC
0
CD
>1
1
0
1
0
OVER
Sampling
Divider
FIDI
11053B–ATARM–22-Sep-11
11053B–ATARM–22-Sep-11
0
1
SYNC
SCK
Baud Rate
Sampling
Clock
Clock