SAM9G10 Atmel Corporation, SAM9G10 Datasheet - Page 782

• Manufacturer Part Number: SAM9G10
• Manufacturer: Atmel Corporation

Specifications of SAM9G10

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 266 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Ssc: 3
• Sd / Emmc: 1
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: No
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.08 to 1.32
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

Notes:
38.10.6
Figure 38-32. Read Write Flowchart in Slave Mode
782
782
1. In this case, if TWI_THR has not been written at the end of the read command, the clock is automatically stretched before
2. TXCOMP is only set at the end of the transmission because after the repeated start, SADR is detected again.
SAM9G35
SAM9G35
Read Write Flowcharts
the ACK.
No
No
SADR + MSDIS + SVEN
Set the SLAVE mode:
Read Status Register
EOSACC = 1 ?
TXCOMP = 1 ?
SVACC = 1 ?
No
END
The flowchart shown in
in Slave mode. A polling or interrupt method can be used to check the status bits. The interrupt
method requires that the interrupt enable register (TWI_IER) be configured first.
GACC = 1 ?
Figure 38-32 on page 782
No
programming sequence
Read TWI_RHR
SVREAD = 0 ?
RXRDY= 0 ?
Decoding of the
Change SADR
Prog seq
OK ?
No
gives an example of read and write operations
No
GENERAL CALL TREATMENT
No
Write in TWI_THR
TXRDY= 1 ?
11053B–ATARM–22-Sep-11
11053B–ATARM–22-Sep-11
No