r5f21368sdfp Renesas Electronics Corporation., r5f21368sdfp Datasheet - Page 146

• Manufacturer Part Number: r5f21368sdfp
• Description: Renesas Mcu R8c Family / R8c/3xt-a Series
• Manufacturer: Renesas Electronics Corporation.

Under development
R8C/36T-A Group
R01UH0240EJ0001 Rev.0.01
Apr 28, 2011
10.4.4
Table 10.3
Serial interface interrupt
Synchronous serial
communication unit interrupt
Key input interrupt
A/D interrupt
Timer RJ interrupt
Timer RB2 interrupt
Timer RC interrupt
Timer RE2 interrupt
INT interrupt
Voltage monitor 1 interrupt
Voltage monitor 2 interrupt
Oscillation stop detection
interrupt
A reset or a peripheral function interrupt is used to exit wait mode.
Peripheral function interrupts are affected by the CM02 bit in the CM0 register. When the CM02 bit is 0
(peripheral function clock does not stop in wait mode), peripheral function interrupts other the A/D conversion
interrupt can be used to exit wait mode. When the CM02 bit is 1 (peripheral function clock stops in wait mode),
the peripheral functions that use the peripheral function clock are stopped. Only the peripheral function
interrupts that operate using external signals or the on-chip oscillator clock can be used to exit wait mode.
Table 10.3 lists the Interrupts Used to Exit Wait Mode and Usage Conditions.
Interrupt
Exiting Wait Mode
Preliminary document
Specifications in this document are tentative and subject to change.
Interrupts Used to Exit Wait Mode and Usage Conditions
Usable with an internal clock or external
clock supplied.
Usable in all modes.
Usable
― (Do not use.)
Usable in all modes.
Usable in all modes.
Usable in all modes.
Usable in all modes.
Usable
Usable
Usable
Usable
When CM02 = 0
Usable with an external clock supplied.
― (Do not use.)
Usable
― (Do not use.)
Usable without a filter in event counter
mode.
Usable when fOCO is selected as the count
source.
― (Do not use.)
Usable when fHOCO or fHOCO-F is
selected as the count source.
― (Do not use.)
Usable (usable when INT0 to INT4 are
used without a filter.)
Usable
Usable
― (Do not use.)
When CM02 = 1
10. Power Control
Page 115 of 725