D12674RVFQ33D Renesas Electronics America, D12674RVFQ33D Datasheet - Page 160

• Manufacturer Part Number: D12674RVFQ33D
• Description: MCU 3V 0K I-TEMP 144-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2600r

Specifications of D12674RVFQ33D

• Core Processor: H8S/2600
• Core Size: 16-Bit
• Speed: 33MHz
• Connectivity: IrDA, SCI
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 103
• Program Memory Type: ROMless
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 12x10b; D/A 4x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 144-LQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Program Memory Size: -
• Other names: HD6412674RVFQ33D; HD6412674RVFQ33D

Section 5 Interrupt Controller
5.6.1
In interrupt control mode 0, interrupt requests except for NMI is masked by the I bit of CCR in the
CPU. Figure 5.3 shows a flowchart of the interrupt acceptance operation in this case.
1. If an interrupt source occurs when the corresponding interrupt enable bit is set to 1, an
2. If the I bit is set to 1, only an NMI interrupt is accepted, and other interrupt requests are held
3. Interrupt requests are sent to the interrupt controller, the highest-ranked interrupt according to
4. When the CPU accepts an interrupt request, it starts interrupt exception handling after
5. The PC and CCR are saved to the stack area by interrupt exception handling. The PC saved on
6. Next, the I bit in CCR is set to 1. This masks all interrupts except NMI.
7. The CPU generates a vector address for the accepted interrupt and starts execution of the
Rev. 3.00 Mar 17, 2006 page 108 of 926
REJ09B0283-0300
interrupt request is sent to the interrupt controller.
pending. If the I bit is cleared, an interrupt request is accepted.
the priority system is accepted, and other interrupt requests are held pending.
execution of the current instruction has been completed.
the stack shows the address of the first instruction to be executed after returning from the
interrupt handling routine.
interrupt handling routine at the address indicated by the contents of the vector address in the
vector table.
Interrupt Control Mode 0