D12674RVFQ33D Renesas Electronics America, D12674RVFQ33D Datasheet - Page 381

• Manufacturer Part Number: D12674RVFQ33D
• Description: MCU 3V 0K I-TEMP 144-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2600r

Specifications of D12674RVFQ33D

• Core Processor: H8S/2600
• Core Size: 16-Bit
• Speed: 33MHz
• Connectivity: IrDA, SCI
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 103
• Program Memory Type: ROMless
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 12x10b; D/A 4x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 144-LQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Program Memory Size: -
• Other names: HD6412674RVFQ33D; HD6412674RVFQ33D

7.6
The sources of interrupts generated by the DMAC are transfer end and transfer break. Table 7.12
shows the interrupt sources and their priority order.
Table 7.12 Interrupt Sources and Priority Order
Enabling or disabling of each interrupt source is set by means of the DTIE bit in DMABCRL for
the corresponding channel in DMABCRL, and interrupts from each source are sent to the interrupt
controller independently. The priority of transfer end interrupts on each channel is decided by the
interrupt controller, as shown in table 7.12.
Figure 7.38 shows a block diagram of a transfer end/transfer break interrupt. An interrupt is
always generated when the DTIE bit is set to 1 while the DTE bit in DMABCRL is cleared to 0.
In full address mode, a transfer break interrupt is generated when the DTME bit is cleared to 0
while the DTIEB bit is set to 1. In both short address mode and full address mode, DMABCR
should be set so as to prevent the occurrence of a combination that constitutes a condition for
interrupt generation during setting.
Interrupt Name
DMTEND0A
DMTEND0B
DMTEND1A
DMTEND1B
Interrupt Sources
DTE/
DTME
Figure 7.38 Block Diagram of Transfer End/Transfer Break Interrupt
DTIE
Interrupt Source
Short Address Mode
Interrupt due to end of
transfer on channel 0A
Interrupt due to end of
transfer on channel 0B
Interrupt due to end of
transfer on channel 1A
Interrupt due to end of
transfer on channel 1B
Full Address Mode
Interrupt due to end of
transfer on channel 0
Interrupt due to break in
transfer on channel 0
Interrupt due to end of
transfer on channel 1
Interrupt due to break in
transfer on channel 1
Rev. 3.00 Mar 17, 2006 page 329 of 926
Section 7 DMA Controller (DMAC)
Transfer end/transfer
break interrupt
Interrupt
Priority Order
High
Low
REJ09B0283-0300