D12674RVFQ33D Renesas Electronics America, D12674RVFQ33D Datasheet - Page 367

• Manufacturer Part Number: D12674RVFQ33D
• Description: MCU 3V 0K I-TEMP 144-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2600r

Specifications of D12674RVFQ33D

• Core Processor: H8S/2600
• Core Size: 16-Bit
• Speed: 33MHz
• Connectivity: IrDA, SCI
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 103
• Program Memory Type: ROMless
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 12x10b; D/A 4x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 144-LQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Program Memory Size: -
• Other names: HD6412674RVFQ33D; HD6412674RVFQ33D

DREQ pin sampling is performed every cycle, with the rising edge of the next cycle after the
end of the DMABCR write cycle for setting the transfer enabled state as the starting point.
When the DREQ pin low level is sampled while acceptance by means of the DREQ pin is
possible, the request is held in the DMAC. Then, when activation is initiated in the DMAC, the
request is cleared, and DREQ pin high level sampling for edge detection is started. If DREQ pin
high level sampling has been completed by the time the DMA dead cycle ends, acceptance
resumes after the end of the dead cycle, DREQ pin low level sampling is performed again, and this
operation is repeated until the transfer ends.
Figure 7.23 Example of DREQ
DREQ
Address
bus
DMA
control
Channel
[1]
[2] [5] The request is cleared at the next bus break, and activation is started in the DMAC.
[3] [6] Start of DMA cycle; DREQ pin high level sampling on the rising edge of
[4] [7] When the DREQ pin high level has been sampled, acceptance is resumed after the dead cycle
Note: In write data buffer mode, bus breaks from [2] to [7] may be hidden, and not visible.
Acceptance after transfer enabling; the DREQ pin low level is sampled on the rising edge of ,
and the request is held.
is completed.
(As in [1], the DREQ pin low level is sampled on the rising edge of , and the request is held.)
Bus release
Idle
[1]
Request
of 2 cycles
Minimum
[2]
Request clear period
Read
[3]
Transfer source
DREQ
DREQ Pin Falling Edge Activated Block Transfer Mode Transfer
DREQ
DMA
read
Write
1 block transfer
Acceptance resumes
Transfer destination
DMA
write
Dead
[4]
Request
DMA
dead
of 2 cycles
Minimum
Idle
[5]
release
Bus
Rev. 3.00 Mar 17, 2006 page 315 of 926
Read
[6]
Transfer source
Section 7 DMA Controller (DMAC)
Request clear period
DMA
read
Write
1 block transfer
starts.
Transfer destination
DMA
write
Dead
REJ09B0283-0300
Acceptance resumes
DMA
dead
[7]
Idle
release
Bus