HD64F3029XBL25V Renesas Electronics America, HD64F3029XBL25V Datasheet - Page 667

• Manufacturer Part Number: HD64F3029XBL25V
• Description: MCU 5V 512K,PB-FREE 100-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300Hr

Specifications of HD64F3029XBL25V

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 25MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 70
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

18.8.1
1. Download time of on-chip program
2. Write to flash-memory related registers by DMAC
3. Compatibility with programming/erasing program of conventional F-ZTAT H8
4. Monitoring runaway by WDT
Rev. 2.0, 06/04, page 638 of 980
The programming program that includes the initialization routine and the erasing program that
includes the initialization routine are each 2 kbytes or less. Accordingly, when the CPU clock
frequency is 25 MHz, the download for each program takes approximately 164 s at
maximum.
While an instruction in on-chip RAM is being executed, the DMAC can write to the SCO bit
in FCCS that is used for a download request or FMATS that is used for MAT switching. Make
sure that these registers are not accidentally written to, otherwise an on-chip program may be
downloaded and damage RAM or a MAT switchover may occur and the CPU get out of
control. Do not use DMAC to program FLASH related registers.
microcomputer
A programming/erasing program for flash memory used in the conventional F-ZTAT H8
microcomputer which does not support download of the on-chip program by a SCO transfer
request cannot run in this LSI.
Be sure to download the on-chip program to execute programming/erasing of flash memory in
this LSI.
Unlike the conventional F-ZTAT H8 microcomputer, no countermeasures are available for a
runaway by WDT during programming/erasing by the downloaded on-chip program.
Prepare countermeasures (e.g. use of the user branch routine and periodic timer interrupts) for
WDT while taking the programming/erasing time into consideration as required.
Usage Notes