HD64F3029XBL25V Renesas Electronics America, HD64F3029XBL25V Datasheet - Page 672

MCU 5V 512K,PB-FREE 100-TQFP

HD64F3029XBL25V

Manufacturer Part Number
HD64F3029XBL25V
Description
MCU 5V 512K,PB-FREE 100-TQFP
Manufacturer
Renesas Electronics America
Series
H8® H8/300Hr
Datasheet

Specifications of HD64F3029XBL25V

Core Processor
H8/300H
Core Size
16-Bit
Speed
25MHz
Connectivity
SCI, SmartCard
Peripherals
DMA, PWM, WDT
Number Of I /o
70
Program Memory Size
512KB (512K x 8)
Program Memory Type
FLASH
Ram Size
16K x 8
Voltage - Supply (vcc/vdd)
3 V ~ 3.6 V
Data Converters
A/D 8x10b; D/A 2x8b
Oscillator Type
Internal
Operating Temperature
-20°C ~ 75°C
Package / Case
100-TQFP, 100-VQFP
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Eeprom Size
-
18.9.4
(1) In auto-program mode, programming is in 128-byte units. That is, 128 bytes of data are
(2) Even in the programming of less than 128 bytes, 128 bytes of data must be transferred. H'FF
(3) Set the low seven bits of the address to be transferred to low level. Inputting an invalid address
(4) The memory address is transferred in the 2
(5) Do not issue commands while programming is in progress.
(6) When programming, execute automatic programming once for each 128-byte block of
(7) To confirm the end of automatic programming, check the signal on the I/O6 pin. Confirmation
(8) Status-polling information on the I/O6 and I/O7 pins is retained until the next command is
For the AC characteristics in auto-program mode, see section 18.10.2, AC Characteristics and
Timing in Writer Mode.
18.9.5
(1) Auto-erase mode only supports erasing of the entire memory.
(2) Do not perform command writing during auto erasing is in progress.
(3) To confirm the end of automatic erasing, check the signal on the I/O6 pin. Confirmation in the
(4) Status polling information on the I/O6 and I/O7 pins is retained until the next command
For the AC characteristics in auto-erase mode, see section 18.10.2, AC Characteristics and Timing
in Writer Mode.
transferred in succession.
should be written to those addresses that are unnecessarily written to.
will result in a programming error, although processing will proceed to the memory-
programming operation.
cycles.
addresses. Programming the block at an address where programming has already been
performed is not possible.
in the status-read mode is also possible (status polling of the I/O7 pin is used to check the end
status of automatic programming).
written. As long as no command is written, the information is made readable by setting CE and
OE for enabling.
status-read mode is also possible (status polling of the I/O7 pin is used to check the end status
of automatic erasure).
writing. As long as no command is written, the information is made readable by setting CE
and OE for enabling.
Auto-Program Mode
Auto-Erase Mode
nd
cycle. Do not transfer addresses in the 3
Rev. 2.0, 06/04, page 643 of 980
rd
or later

Related parts for HD64F3029XBL25V