R88M-WP10030S-BWS1 Omron, R88M-WP10030S-BWS1 Datasheet - Page 116

• Manufacturer Part Number: R88M-WP10030S-BWS1
• Description: SERVO MOTOR 100W 100V W/BRAKE
• Manufacturer: Omron

Specifications of R88M-WP10030S-BWS1

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: R88MWP10030SBWS1

Standard Models and Specifications
D Brake Interlock Output (Not Allocated: BKIR)
External brake timing signals are output according to the settings in Pn506 (brake timing 1), Pn507
(brake command speed), and Pn508 (brake timing 2).
Note 1. The BKIR signal is not allocated by default. It is allocated by Pn50F.2.
Note 2. For details on the brake interlock function, refer to 4-5-8 Brake Interlock (All Operating
D Warning Output (Not Allocated: WARN)
The WARN signal is turned ON in any of the following three cases:
Note The WARN signal is not allocated by default. It is allocated by Pn50F.3.
D Command Pulse Factor Enabled Output (Not Allocated: PSON)
The PSON signal turns ON when the command pulse factor has changed after the PSEL (command
pulse factor switching) input has been turned ON. After the PSEL input is turned OFF, PSON turns OFF
when the command pulse factor returns to 1.
Note 1. Refer to the information on the PSEL signal for details on timing for switching the command
Note 2. When command pulse factor switching is used, set Pn218.0 (command pulse factor switching
Note 3. Allocate the PSEL signal using Pn513.0.
Note 4. The PSON signal is not allocated by default. The PSON signal is allocated using Pn510.2.
2-4-5 Encoder Input Specifications (CN2)
2-88
1
2
3
4
5
6
Shell
Pin No.
S The Servomotor output torque (effective value) exceeds 115% of the rated torque.
S The regenerative energy exceeds the tolerance of the internal regeneration resistance.
S When external regeneration resistance is used, the regenerative energy exceeds the value set for
Pn600 (regeneration resistor capacity).
Modes) .
pulse factor.
function selection) to 1, and set the applicable factor in Pn217.
E5V
E0V
BAT+
BAT–
S+
S–
FG
Symbol
Encoder power supply +5 V
Encoder power supply GND
Battery + [absolute]
Battery – [absolute]
Encoder + phase-S input
Encoder – phase-S input
Shielded ground
Signal name
Power supply outlet for encoder: 5 V, 180 mA
Note An automatic reset fuse is provided to
Backup power output for encoder
(3 6 V 20 μA for backup or when stopped;
(3.6 V, 20 μA for backup or when stopped;
3 μA when Servo Driver is being powered)
Line driver input (conforming to EIA-RS422A)
(Input impedance: 120 Ω)
(I
Cable shielded ground
i
protect output. If the fuse is activated
due to overcurrent, it will automatical-
due to overcurrent, it will automatical-
ly reset after a fixed period of time has
lapsed without current flowing (sup-
ported by Servo Drivers with software
version “r.0037” or later).
d
p
Function/Interface
(
)
g
Chapter 2
)