R88M-WP10030S-BWS1 Omron, R88M-WP10030S-BWS1 Datasheet - Page 350

• Manufacturer Part Number: R88M-WP10030S-BWS1
• Description: SERVO MOTOR 100W 100V W/BRAKE
• Manufacturer: Omron

Specifications of R88M-WP10030S-BWS1

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: R88MWP10030SBWS1

Operation
H Operation
Note When a positive voltage speed feed-forward is added, a command to rotate the Servomotor for-
4-8-5
H Functions
• This function switches the speed loop and position loop gain.
• If GSEL (gain switching) signal is not being input, perform control using Pn100 (speed loop gain),
• If the mechanical system inertia fluctuates too much, or if there is no difference between operation and
• If online auto-tuning is not enabled (under the conditions shown below), the gain switching function will
Note When No. 2 gain has been selected (i.e., GSEL ON), online auto-tuning will not operate normally.
4-112
Position command
REF (speed feed-
forward input
Pn101 (speed loop integration constant), and Pn102 (position loop gain). If GSEL is being input, per-
form control using Pn104 (speed loop gain 2), Pn105 (speed loop integration constant 2), and Pn106
(position loop gain 2).
standby responses, you can perform applicable control using gain switching.
be enabled.
Servomotor operation
wards is added. If a reverse feed-forward command is added to the pulse train, positioning time
will be lengthened, so check the polarity carefully.
• When using the torque feed-forward function.
• When the load inertia fluctuates by 200 ms max.
• When rotation speed does not exceed 500 r/min., or output torque does not exceed 50% of rated
• External force is constantly applied, as with a vertical axis.
If using the gain switching function, turn OFF online auto-tuning (Pn110.0 = 2).
torque.
Gain Switching (Position, Speed, Internally-set Speed
Control)
Without the feed-forward
function
Chapter 4