R88M-WP10030S-BWS1 Omron, R88M-WP10030S-BWS1 Datasheet - Page 256

• Manufacturer Part Number: R88M-WP10030S-BWS1
• Description: SERVO MOTOR 100W 100V W/BRAKE
• Manufacturer: Omron

Specifications of R88M-WP10030S-BWS1

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: R88MWP10030SBWS1

Operation
Example of an n. + 4 Digits Parameter Setting
Saving the Changed Setting to Memory
• The following operation is not necessary if you are only checking the settings.
D Return to Parameter Number Display
4-4-2 Parameter Tables
• Some parameters are enabled by turning OFF the Unit, then turning it ON again. (See the tables be-
• The specific digit number of a parameter for which each digit number must be set separately is dis-
• The default setting for parameters set using 5 digits are displayed in the table with the leftmost digits
• Do not set parameters or digit numbers shown as “Not used.”
• Parameters marked with one asterisk are for the DeviceNet Option Unit. Do not change the settings of
• Parameters marked with two asterisks are supported by Servo Drivers with software version “r.0037.”
4-18
(After approx. 1 s)
operation
operation
operation
low.) When changing these parameters, turn OFF the power (check that the power lamp is not lit), then
turn ON the power again.
played in the table with “.0” added to the digit number. For example, Pn001.0 (i.e., digit No. 0 of param-
eter No. Pn001).
not shown if they are 0 (e.g., if the default setting is 00080, 80 is entered in the table).
these parameters unless a DeviceNet Option Unit is mounted.
PR02W
PR02W
PR02W
key operation
key operation
key operation
Front panel
Front panel
Front panel
(1 s min.)
(1 s min.)
(less than
1 s)
Display example
Display example
Display example
Digit No. 3 Digit No. 0
(Present setting)
Set the digit No. to be operated using the Left Key (front
panel: DATA Key for less than 1 s) or Right Key. You
cannot use only the Up and Down Keys.
Press the DATA Key (front panel: DATA Key for 1 s min.)
to save the data to memory (the setting display will flash
for approximately 1 s).
After the display has finished flashing, it will return to
normal.
Press the DATA Key (front panel: DATA Key for 1 s min.)
to return to the parameter No. display.
Explanation
Explanation
Explanation
Chapter 4