R88M-WP10030S-BWS1 Omron, R88M-WP10030S-BWS1 Datasheet - Page 413

• Manufacturer Part Number: R88M-WP10030S-BWS1
• Description: SERVO MOTOR 100W 100V W/BRAKE
• Manufacturer: Omron

Specifications of R88M-WP10030S-BWS1

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: R88MWP10030SBWS1

Troubleshooting
5-5
Maintenance and Inspection Precautions
The periodic maintenance cycle depends on the installation environment and application conditions of
the Servomotor or Driver. Recommended maintenance times are listed below for Servomotors and
Drivers. Use these for reference in determining actual maintenance schedules.
H Servomotors
• Recommended Periodic Maintenance
• The radial loads during operation (rotation) on timing pulleys and other components contacting belts is
H Servo Drivers
• Recommended Periodic Maintenance
!
!
Application Conditions: Ambient Servomotor operating temperature of 40_C, within allowable shaft
twice the still load. Consult with the belt and pulley manufacturers and adjust designs and system set-
tings so that the allowable shaft load is not exceeded even during operation. If a Servomotor is used
under a shaft load exceeding the allowable limit, the Servomotor shaft can break, the bearings can
burn out, and other problems can occur.
WARNING
Caution
Aluminum analytical capacitors: 50,000 hours, at an ambient Servo Driver operating temperature
Axle fan: 30,000 hours, at an ambient Servo Driver operating temperature of 40_C and an ambi-
Absolute encoder backup battery:
Bearings:
Reduction gear:
Oil seal:
Servomotors and Servo Drivers contain many components and will operate properly
only when each of the individual components is operating properly. Some of the electri-
cal and mechanical components require maintenance depending on application condi-
tions. In order to ensure proper long-term operation of Servomotors and Drivers, period-
ic inspection and part replacement is required according to the life of the components.
Periodic Maintenance
ent humidity of 65%.
50,000 hours, at an ambient Servo Driver operating temperature of 20_C.
Do not attempt to disassemble, repair, or modify any Units. Any attempt to do so may
result in malfunction, fire, or electric shock.
Resume operation only after transferring to the new Unit the contents of the data
required for operation. Not doing so may result in an unexpected operation.
20,000 hours
20,000 hours
5,000 hours
load, rated operation (rated torque and r/m), installed as described in opera-
tion manual.
of 40_C, rated operation (rated torque), installed as described in
operation manual.
Chapter 5
5-21