MOD5234-100IR NetBurner Inc, MOD5234-100IR Datasheet - Page 552

• Manufacturer Part Number: MOD5234-100IR
• Description: MOD5234 10/100 ETHERNET MODULE
• Manufacturer: NetBurner Inc
• Type: Controllers & Processorsr

Specifications of MOD5234-100IR

• Interface: I²C, SPI, UART
• Voltage - Supply: 2.5V
• Mounting Type: Surface Mount
• Package / Case: Module
• Product: Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Data Format: -
• Baud Rates: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: Q4483564

UART Modules
After the stop bits are sent, if no new character is in the transmitter holding register, the UnTXD
output remains high (mark condition) and the transmitter empty bit, USRn[TxEMP], is set.
Transmission resumes and TxEMP is cleared when the CPU loads a new character into the UART
transmit buffer (UTBn). If the transmitter receives a disable command, it continues until any
character in the transmitter shift register is completely sent.
If the transmitter is reset through a software command, operation stops immediately (see
Section 26.3.5, “UART Command Registers
(UCRn)”). The transmitter is reenabled through the
UCRn to resume operation after a disable or software reset.
If the clear-to-send operation is enabled, UnCTS must be asserted for the character to be
transmitted. If UnCTS is negated in the middle of a transmission, the character in the shift register
is sent and UnTXD remains in mark state until UnCTSn is reasserted. If the transmitter is forced
to send a continuous low condition by issuing a
command, the transmitter ignores the
SEND BREAK
state of UnCTS.
If the transmitter is programmed to automatically negate UnRTS when a message transmission
completes, UnRTS must be asserted manually before a message is sent. In applications in which
the transmitter is disabled after transmission is complete and UnRTS is appropriately
programmed, UnRTS is negated one bit time after the character in the shift register is completely
transmitted. The transmitter must be manually reenabled by reasserting UnRTS before the next
message is to be sent.
Figure 26-19
shows the functional timing information for the transmitter.
MCF5235 Reference Manual, Rev. 2
26-20
Freescale Semiconductor