ATxmega128B1 Atmel Corporation, ATxmega128B1 Datasheet - Page 131

• Manufacturer Part Number: ATxmega128B1
• Manufacturer: Atmel Corporation

Specifications of ATxmega128B1

• Flash (kbytes): 128 Kbytes
• Pin Count: 100
• Max. Operating Frequency: 32 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 16
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 53
• Ext Interrupts: 53
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 3
• Twi (i2c): 1
• Uart: 2
• Segment Lcd: 160
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 16
• Adc Resolution (bits): 12
• Adc Speed (ksps): 2000
• Analog Comparators: 4
• Resistive Touch Screen: No
• Temp. Sensor: Yes
• Crypto Engine: AES/DES
• Sram (kbytes): 8
• Eeprom (bytes): 2048
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: Yes
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.6 to 3.6
• Operating Voltage (vcc): 1.6 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 3
• Output Compare Channels: 10
• Input Capture Channels: 10
• Pwm Channels: 10
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

12.3.1.2
12.3.2
12.3.3
8291A–AVR–10/11
Bus-keeper
Wired-OR
Totem-pole with Pull-up
In this mode, the configuration is as for totem-pole, expect the pin is configured with internal pull-
up when set as input.
Figure 12-4. I/O pin configuration - Totem-pole with pull-up (on input).
In the bus-keeper configuration, it provides a weak bus-keeper that will keep the pin at its logic
level when the pin is no longer driven to high or low. If the last level on the pin/bus was 1, the
bus-keeper configuration will use the internal pull resistor to keep the bus high. If the last logic
level on the pin/bus was 0, the bus-keeper will use the internal pull resistor to keep the bus low.
Figure 12-5. I/O pin configuration - Totem-pole with bus-keeper.
In the wired-OR configuration, the pin will be driven high when the corresponding bits in the OUT
and DIR registers are written to one. When the OUT register is set to zero, the pin is released,
allowing the pin to be pulled low with the internal or an external pull-resistor. If internal pull-down
is used, this is also active if the pin is set as input.
OUTn
OUTn
DIRn
DIRn
INn
INn
Atmel AVR XMEGA B
Pn
Pn
131