LPC1112FHN33/203,5 NXP Semiconductors, LPC1112FHN33/203,5 Datasheet - Page 436

• Manufacturer Part Number: LPC1112FHN33/203,5
• Description: ARM Microcontrollers - MCU Cortex-M0 16kB flash up to 4 kB SRAM
• Manufacturer: NXP Semiconductors

Specifications of LPC1112FHN33/203,5

• Rohs: yes
• Core: ARM Cortex M0
• Processor Series: LPC1112
• Data Bus Width: 32 bit
• Maximum Clock Frequency: 50 MHz
• Program Memory Size: 16 KB
• Data Ram Size: 4 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 1.8 V to 3.6 V
• Operating Temperature Range: - 65 C to + 150 C
• Package / Case: HVQFN-33
• Mounting Style: SMD/SMT
• Factory Pack Quantity: 260

NXP Semiconductors
26.8 Debug notes
UM10398
User manual
26.7.11 IAP Status Codes
26.8.1 Comparing flash images
26.8.2 Serial Wire Debug (SWD) flash programming interface
Table 405. IAP Status Codes Summary
Depending on the debugger used and the IDE debug settings, the memory that is visible
when the debugger connects might be the boot ROM, the internal SRAM, or the flash. To
help determine which memory is present in the current debug environment, check the
value contained at flash address 0x0000 0004. This address contains the entry point to
the code in the ARM Cortex-M0 vector table, which is the bottom of the boot ROM, the
internal SRAM, or the flash memory respectively.
Table 406. Memory mapping in debug mode
Debug tools can write parts of the flash image to RAM and then execute the IAP call
"Copy RAM to flash" repeatedly with proper offset.
Status
Code
0
1
2
3
4
5
6
7
8
9
10
11
Memory mapping mode
Bootloader mode
User flash mode
User SRAM mode
Mnemonic
CMD_SUCCESS
INVALID_COMMAND
SRC_ADDR_ERROR
DST_ADDR_ERROR
SRC_ADDR_NOT_MAPPED
DST_ADDR_NOT_MAPPED
COUNT_ERROR
INVALID_SECTOR
SECTOR_NOT_BLANK
SECTOR_NOT_PREPARED_
FOR_WRITE_OPERATION
COMPARE_ERROR
BUSY
All information provided in this document is subject to legal disclaimers.
Rev. 12 — 24 September 2012
Chapter 26: LPC111x/LPC11Cxx Flash programming firmware
Description
Command is executed successfully.
Invalid command.
Source address is not on a word boundary.
Destination address is not on a correct boundary.
Source address is not mapped in the memory map.
Count value is taken in to consideration where
applicable.
Destination address is not mapped in the memory
map. Count value is taken in to consideration where
applicable.
Byte count is not multiple of 4 or is not a permitted
value.
Sector number is invalid.
Sector is not blank.
Command to prepare sector for write operation was
not executed.
Source and destination data is not same.
Flash programming hardware interface is busy.
Memory start address visible at 0x0000 0004
0x1FFF 0000
0x0000 0000
0x1000 0000
UM10398
© NXP B.V. 2012. All rights reserved.
436 of 538