UPD78F1152AGC-GAD-AX Renesas Electronics America, UPD78F1152AGC-GAD-AX Datasheet - Page 37

• Manufacturer Part Number: UPD78F1152AGC-GAD-AX
• Description: MCU 16BIT 78K0R/KX3 80-LQFP
• Manufacturer: Renesas Electronics America
• Series: 78K0R/Kx3r

Specifications of UPD78F1152AGC-GAD-AX

• Core Processor: 78K/0R
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: 3-Wire SIO, I²C, LIN, UART/USART
• Peripherals: DMA, LVD, POR, PWM, WDT
• Number Of I /o: 65
• Program Memory Size: 64KB (64K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 5.5 V
• Data Converters: A/D 8x10b, D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

(2) Control mode
2.2.5 P40 to P47 (port 4)
a flash memory programmer/debugger, clock output, and timer I/O.
using port input mode register 4 (PIM4).
tolerance) in 1-bit units using port output mode register 4 (POM4).
(1) Port mode
(2) Control mode
P40 to P47 function as an 8-bit I/O port. These pins also function as serial interface data I/O, clock I/O, data I/O for
Input to the P43 and P44 pins can be specified through a normal input buffer or a TTL input buffer in 1-bit units
Output from the P43 and P45 pins can be specified as normal CMOS output or N-ch open-drain output (V
The following operation modes can be specified in 1-bit units.
P30 and P31 function as external interrupt request input, timer I/O, and real-time counter correction clock output.
(a) INTP3, INTP4
(b) TI03
(c) TO03
(d) RTC1HZ
P40 to P47 function as an 8-bit I/O port. P40 to P47 can be set to input or output port in 1-bit units using port
mode register 4 (PM4). Use of an on-chip pull-up resistor can be specified by pull-up resistor option register 4
(PU4).
Be sure to connect an external pull-up resistor to P40 when on-chip debugging is enabled (by using an option
byte).
P40 to P45 function as serial interface data I/O, clock I/O, data I/O for a flash memory programmer/debugger,
clock output, and timer I/O.
(a) TOOL0
These are the external interrupt request input pins for which the valid edge (rising edge, falling edge, or both
rising and falling edges) can be specified.
This is a pin for inputting an external count clock/capture trigger to 16-bit timer 03.
This is a timer output pin from 16-bit timer 03.
This is a real-time counter correction clock (1 Hz) output pin.
This is a data I/O pin for a flash memory programmer/debugger.
Be sure to pull up this pin externally when on-chip debugging is enabled (pulling it down is prohibited).
CHAPTER 2 PIN FUNCTIONS
User’s Manual U17893EJ8V0UD
35
DD