UPD78F1152AGC-GAD-AX Renesas Electronics America, UPD78F1152AGC-GAD-AX Datasheet - Page 515

• Manufacturer Part Number: UPD78F1152AGC-GAD-AX
• Description: MCU 16BIT 78K0R/KX3 80-LQFP
• Manufacturer: Renesas Electronics America
• Series: 78K0R/Kx3r

Specifications of UPD78F1152AGC-GAD-AX

• Core Processor: 78K/0R
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: 3-Wire SIO, I²C, LIN, UART/USART
• Peripherals: DMA, LVD, POR, PWM, WDT
• Number Of I /o: 65
• Program Memory Size: 64KB (64K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 5.5 V
• Data Converters: A/D 8x10b, D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

13.5 I
Figure 13-13 shows the transfer timing for the “start condition”, “address”, “data”, and “stop condition” output via the
I
The acknowledge (ACK) can be generated by either the master or slave device (normally, it is output by the device
that receives 8-bit data).
level period can be extended and a wait can be inserted.
13.5.1 Start conditions
The start conditions for the SCL0 pin and SDA0 pin are signals that the master device generates to the slave device
when starting a serial transfer. When the device is used as a slave, start conditions can be detected.
been detected (SPD0: Bit 0 = 1 in IIC status register 0 (IICS0)). When a start condition is detected, bit 1 (STD0) of
IICS0 is set (to 1).
2
C bus’s serial data bus.
The following section describes the I
The master device generates the start condition, slave address, and stop condition.
The serial clock (SCL0) is continuously output by the master device. However, in the slave device, the SCL0’s low
A start condition is met when the SCL0 pin is at high level and the SDA0 pin changes from high level to low level.
A start condition is output when bit 1 (STT0) of IIC control register 0 (IICC0) is set (to 1) after a stop condition has
2
C Bus Definitions and Control Methods
SDA0
SCL0
Start
condition
Figure 13-13. I
Address R/W ACK
1-7
SDA0
SCL0
CHAPTER 13 SERIAL INTERFACE IIC0
2
C bus’s serial data communication format and the signals used by the I
Figure 13-14. Start Conditions
8
H
User’s Manual U17893EJ8V0UD
2
C Bus Serial Data Transfer Timing
9
Data
1-8
ACK
9
Data
1-8
ACK
9
Stop
condition
2
C bus.
513