UPD78F1152AGC-GAD-AX Renesas Electronics America, UPD78F1152AGC-GAD-AX Datasheet - Page 670

• Manufacturer Part Number: UPD78F1152AGC-GAD-AX
• Description: MCU 16BIT 78K0R/KX3 80-LQFP
• Manufacturer: Renesas Electronics America
• Series: 78K0R/Kx3r

Specifications of UPD78F1152AGC-GAD-AX

• Core Processor: 78K/0R
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: 3-Wire SIO, I²C, LIN, UART/USART
• Peripherals: DMA, LVD, POR, PWM, WDT
• Number Of I /o: 65
• Program Memory Size: 64KB (64K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 5.5 V
• Data Converters: A/D 8x10b, D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

(2) When detecting level of input voltage from external input pin (EXLVI)
668
• When starting operation
• When stopping operation
Either of the following procedures must be executed.
•
Figure 21-10 shows the timing of the interrupt signal generated by the low-voltage detector. The numbers in
this timing chart correspond to <1> to <7> above.
Caution Input voltage from external input pin (EXLVI) must be EXLVI < V
•
<1>
<2>
<3>
<4>
<5>
<6>
<7>
<8>
When using 8-bit memory manipulation instruction:
Write 00H to LVIM.
When using 1-bit memory manipulation instruction:
Clear LVION to 0.
Mask the LVI interrupt (LVIMK = 1).
Set bit 2 (LVISEL) of the low-voltage detection register (LVIM) to 1 (detects level of input voltage from
external input pin (EXLVI)).
Clear bit 1 (LVIMD) of LVIM to 0 (generates interrupt signal when the level is detected) (default value).
Set bit 7 (LVION) of LVIM to 1 (enables LVI operation).
Use software to wait for the following periods of time (Total 410
Confirm that “input voltage from external input pin (EXLVI) ≥ detection voltage (V
when detecting the falling edge of EXLVI, or “input voltage from external input pin (EXLVI) < detection
voltage (V
Clear the interrupt request flag of LVI (LVIIF) to 0.
Release the interrupt mask flag of LVI (LVIMK).
Execute the EI instruction (when vector interrupts are used).
•
•
•
Operation stabilization time (10
Minimum pulse width (200
Detection delay time (200
EXLVI
= 1.21 V (TYP.))” when detecting the rising edge of EXLVI, at bit 0 (LVIF) of LVIM.
CHAPTER 21 LOW-VOLTAGE DETECTOR
μ
User’s Manual U17893EJ8V0UD
μ
s (MAX.))
s (MIN.))
μ
s (MAX.))
μ
s).
DD
.
EXLVI
= 1.21 V (TYP.))”