UPD78F1152AGC-GAD-AX Renesas Electronics America, UPD78F1152AGC-GAD-AX Datasheet - Page 539

• Manufacturer Part Number: UPD78F1152AGC-GAD-AX
• Description: MCU 16BIT 78K0R/KX3 80-LQFP
• Manufacturer: Renesas Electronics America
• Series: 78K0R/Kx3r

Specifications of UPD78F1152AGC-GAD-AX

• Core Processor: 78K/0R
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: 3-Wire SIO, I²C, LIN, UART/USART
• Peripherals: DMA, LVD, POR, PWM, WDT
• Number Of I /o: 65
• Program Memory Size: 64KB (64K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 5.5 V
• Data Converters: A/D 8x10b, D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Remark
The main processing of the slave operation is explained next.
Start serial interface IIC0 and wait until communication is enabled. When communication is enabled, execute
communication by using the communication mode flag and ready flag (processing of the stop condition and
start condition is performed by an interrupt. Here, check the status by using the flags).
The transmission operation is repeated until the master no longer returns ACK. If ACK is not returned from the
master, communication is completed.
For reception, the necessary amount of data is received. When communication is completed, ACK is not
returned as the next data. After that, the master generates a stop condition or restart condition. Exit from the
communication status occurs in this way.
Conform to the specifications of the product that is in communication, regarding the transmission and
reception formats.
No
No
No
ACKE = WTIM = 1, SPIE = 0
Clearing communication
IICC0 ← 0XX011XXB
IICC0 ← 1XX011XXB
Clearing ready flag
direction flag = 1?
direction flag = 1?
Communication
Ready flag =
Communication
Communication
mode flag = 1?
Communication
IICCL0 ← XXH
Setting IICRSV
mode flag = 1?
IICX0 ← 0XH
SVA0 ← XXH
IICF0 ← 0XH
ACKD0 = 1?
Setting port
Writing IIC0
WREL0 = 1
Setting port
mode flag
IICE = 1
START
Figure 13-26. Slave Operation Flowchart (1)
Yes
Yes
Yes
Yes
Yes
No
1?
CHAPTER 13 SERIAL INTERFACE IIC0
No
No
Yes
Sets the port from input mode to output mode and enables the output of the I
(see 13.3 (7) Port mode register 6 (PM6)).
Starts
transmission.
Selects a transfer clock.
Sets a local address.
Sets a start condition.
Sets the port used alternatively as the pin to be used.
First, set the port to input mode and the output latch to 0 (see 13.3 (7) Port mode register 6 (PM6)).
User’s Manual U17893EJ8V0UD
No
Clearing ready flag
direction flag = 0?
Communication
Communication
mode flag = 1?
Ready flag =
Reading IIC0
WREL0 = 1
Yes
Yes
Yes
1?
No
No
Starts
reception.
2
C bus
537