r5f71374an80fpv Renesas Electronics Corporation., r5f71374an80fpv Datasheet - Page 1005

• Manufacturer Part Number: r5f71374an80fpv
• Description: 32-bit Risc Microcomputer Superh?? Risc Engine Family
• Manufacturer: Renesas Electronics Corporation.

Table 22.16 Error Codes
22.9.2
In the descriptions in the previous section, storable areas for the programming/erasing procedure
programs and program data are assumed to be in on-chip RAM. However, the procedure programs
and data can be stored in and executed from other areas (e.g. external address space) as long as the
following conditions are satisfied.
1. The on-chip programming/erasing program is downloaded from the address set by FTDAR in
2. The on-chip programming/erasing program will use 128 bytes or more as a stack. Make sure
3. Since download by setting the SCO bit to 1 will cause the MATs to be switched, it should be
4. The flash memory is accessible until the start of programming or erasing, that is, until the
Code
H'00
H'11
H'21
H'22
H'24
H'25
H'26
H'27
H'29
H'2A
H'2B
H'51
H'52
H'53
H'54
H'80
H'FF
on-chip RAM, therefore, this area is not available for use.
this area is reserved.
executed in on-chip RAM.
result of downloading has been decided. When in a mode in which the external address space
Areas for Storage of the Procedural Program and Data for Programming
Description
No error
Sum check error
Non-matching device code error
Non-matching clock mode error
Bit-rate selection failure
Input frequency error
Frequency multiplier error
Operating frequency error
Block number error
Address error
Data length error (size error)
Erasure error
Non-erased error
Programming error
Selection processing error
Command error
Bit-rate matching acknowledge error
Rev. 1.00 Sep. 21, 2007 Page 979 of 1124
Section 22 Flash Memory
REJ09B0402-0100