r5f71374an80fpv Renesas Electronics Corporation., r5f71374an80fpv Datasheet - Page 878

• Manufacturer Part Number: r5f71374an80fpv
• Description: 32-bit Risc Microcomputer Superh?? Risc Engine Family
• Manufacturer: Renesas Electronics Corporation.

Section 20 Pin Function Controller (PFC)
20.2
1. In this LSI, the same function is available as a multiplexed function on multiple pins. This
Table 20.14 Transmit Forms of Input Functions Allocated to Multiple Pins
2. When the port input is switched from a low level to the IRQ edge for the pins that are
3. Do not set functions other than those specified in tables 20.10 to 20.12. Otherwise, correct
4. PFC setting in single-chip mode (MCU operating mode 3)
Rev. 1.00 Sep. 21, 2007 Page 852 of 1124
REJ09B0402-0100
OR Type
SCK0 to SCK2, RXD0 to RXD2
approach is intended to increase the number of selectable pin functions and to allow the easier
design of boards. If two or more pins are specified for one function, however, there are two
cautions shown below.
 When the pin function is input
 When the pin function is output
multiplexed with input/output and IRQ, the corresponding edge is detected.
operation cannot be guaranteed.
In single-chip mode, do not set the PFC to select address bus, data bus, bus control, or the
BREQ, BACK, or CK signals. If they are selected, address bus signals function as high- or
low-level outputs, data bus signals function as high-impedance outputs, and the other output
signals function as high-level outputs. As BREQ and WAIT function as inputs, do not leave
them open. However, the bus-mastership-request inputs and external waits are disabled.
Signals input to several pins are formed as one signal through OR or AND logic and the
signal is transmitted into the LSI. Therefore, a signal that differs from the input signals may
be transmitted to the LSI depending on the input signals in other pins that have the same
functions. Table 20.14 shows the transmit forms of input functions allocated to several
pins. When using one of the functions shown below in multiple pins, use it with care of
signal polarity considering the transmit forms.
OR type:
AND type: Signals input to several pins are formed as one signal through AND logic and
Each selected pin can output the same function.
Usage Notes
Signals input to several pins are formed as one signal through OR logic and the
signal is transmitted into the LSI.
the signal is transmitted into the LSI.
AND Type
IRQ0 to IRQ3, WAIT, POE0, POE1, POE4 to
POE5