r5f71374an80fpv Renesas Electronics Corporation., r5f71374an80fpv Datasheet - Page 259

• Manufacturer Part Number: r5f71374an80fpv
• Description: 32-bit Risc Microcomputer Superh?? Risc Engine Family
• Manufacturer: Renesas Electronics Corporation.

CK. The bus control signals such as CSn are placed in the high-impedance state at subsequent
rising edges of CK. These bus control signals go high one cycle before being placed in the high-
impedance state. Bus request signals are sampled at the falling edge of CK.
The sequence for reclaiming the bus mastership from an external device is described below.
At 1.5 cycles after the negation of BREQ is detected at the falling edge of CK, the bus control
signals are driven high. The bus acknowledge signal is negated at the next falling edge of the
clock. The fastest timing at which actual bus cycles can be resumed after bus control signal
assertion is at the rising edge of the CK where address and data signals are driven. Figure 9.10
shows the bus arbitration timing in master mode.
After BREQ assertion (low level; bus request), the BREQ signal should be negated (high level;
bus release) only after the BACK is asserted (low level; bus acknowledge). If BREQ is negated
before BACK is asserted, BACK may be asserted only for one cycle depending on the BREQ
negation timing, and a bus conflict may occur between the external device and this LSI.
Acceptance of mastership for the DTC in bus arbitration does not require the insertion of a NOP,
so bus access proceeds continuously.
control signals
A19 to A0
Other bus
D7 to D0
BREQ
BACK
CSn
CK
Figure 9.10 Bus Arbitration Timing
Rev. 1.00 Sep. 21, 2007 Page 233 of 1124
Section 9 Bus State Controller (BSC)
REJ09B0402-0100