HD6417720BP133BV Renesas Electronics America, HD6417720BP133BV Datasheet - Page 1068

• Manufacturer Part Number: HD6417720BP133BV
• Description: SH3-DSP, WITH USB AND LCDC, PB-F
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7700r

Specifications of HD6417720BP133BV

• Core Processor: SH-3 DSP
• Core Size: 32-Bit
• Speed: 133MHz
• Connectivity: FIFO, I²C, IrDA, MMC, SCI, SD, SIO, SIM, USB
• Peripherals: DMA, LCD, POR, WDT
• Number Of I /o: 117
• Program Memory Type: ROMless
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 1.4 V ~ 1.6 V
• Data Converters: A/D 4x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 256-BGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -

Section 30 SIM Card Module (SIM)
3. The smart card interface then returns the data line to high impedance. The data line is held at
4. The receive side performs a parity check.
5. If the transmit side does not receive an error signal, the next frame is transmitted.
30.4.3
Table 30.2 shows a map of the bits in the registers used by the smart card interface.
Bits for which 0 or 1 is shown must always be set to the value shown. The method for setting the
bits other than these is explained below.
Page 1008 of 1414
high level by the pull-up resistance.
If there is no parity error and reception is normal, reception of the next frame is awaited,
without further action.
On the other hand, when a parity error has occurred in T = 0 mode, an error signal (DE: low
level) is output, requesting data retransmission. After output of an error signal with the
specified duration, the receive side again sets the signal line to the high-impedance state. The
signal line returns to high level by means of the pull-up resistance. If in T = 1 mode, however,
no error signal is output even if a parity error occurs.
On the other hand, if in T = 0 mode and an error signal is received, the data for which the error
occurred is retransmitted as in step 2 above. In T = 1 mode, however, error signals are not
received and retransmission is not performed.
Register Settings
SH7720 Group, SH7721 Group
R01UH0083EJ0400 Rev. 4.00
Sep 21, 2010