DF2117VT20V Renesas Electronics America, DF2117VT20V Datasheet - Page 895

• Manufacturer Part Number: DF2117VT20V
• Description: MCU 16BIT FLASH 3V 160K 144-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2100r

Specifications of DF2117VT20V

• Core Processor: H8S/2600
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: FIFO, I²C, LPC, SCI, SmartCard
• Peripherals: POR, PWM, WDT
• Number Of I /o: 112
• Program Memory Size: 160KB (160K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 16x10b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 144-TQFP, 144-VQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Section 26 Power-Down Modes
26.6
Watch Mode
The CPU makes a transition to watch mode when the SLEEP instruction is executed in high-speed
mode with the SSBY bit in SBYCR set to 1, the DTON bit in LPWRCR cleared to 0, and the PSS
bit in TCSR (WDT_1) set to 1.
In watch mode, the CPU is stopped and on-chip peripheral modules other than CIR and WDT_1
are also stopped. The contents of the CPU’s internal registers, several on-chip peripheral module
registers, and on-chip RAM data are retained and the I/O ports retain their values before transition
as long as the prescribed voltage is supplied.
Watch mode is cleared by an interrupt (WOVI1, NMI, IRQ0 to IRQ15, KIN0 to KIN15, or WUE8
to WUE15), PS2 interrupt, CIR interrupt, or RES pin input.
When an interrupt occurs, watch mode is cleared and a transition is made to high-speed mode or
medium-speed mode. When a transition is made to high-speed mode, a stable clock is supplied to
the entire LSI and interrupt exception handling starts after the time set in the STS2 to STS0 bits in
SBYCR has elapsed. In the case of an IRQ0 to IRQ15 interrupt, watch mode is not cleared if the
corresponding enable bit has been cleared to 0 or the interrupt has been masked by the CPU. In the
case of a KIN0 to KIN15 or WUE8 to WUE15 interrupt, watch mode is not cleared if the input is
disabled or the interrupt has been masked by the CPU. In the case of an interrupt from an on-chip
peripheral module, watch mode is not cleared if the interrupt enable register has been set to disable
the reception of that interrupt or the interrupt has been masked by the CPU.
When the RES pin is driven low, the clock pulse generator starts oscillation. Simultaneously with
the start of system clock oscillation, the system clock is supplied to the entire LSI. Note that the
RES pin must be held low until clock oscillation is stabilized. If the RES pin is driven high after
the clock oscillation stabilization time has elapsed, the CPU starts reset exception handling.
Rev. 2.00 Sep. 28, 2009 Page 853 of 994
REJ09B0452-0200