HD6417706F133 Renesas Electronics America, HD6417706F133 Datasheet - Page 280

• Manufacturer Part Number: HD6417706F133
• Description: IC SUPERH MPU ROMLESS 176LQFP
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7700r

Specifications of HD6417706F133

• Core Processor: SH-3
• Core Size: 32-Bit
• Speed: 133MHz
• Connectivity: EBI/EMI, FIFO, SCI, SmartCard
• Peripherals: DMA, POR, WDT
• Number Of I /o: 103
• Program Memory Type: ROMless
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 1.75 V ~ 2.05 V
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 176-LQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Program Memory Size: -
• Data Converters: -

Section 8 Bus State Controller (BSC)
2. Self-Refreshing
Rev. 5.00 May 29, 2006 page 230 of 698
REJ09B0146-0500
Self-refresh mode is a kind of standby mode in which the refresh timing and refresh addresses
are generated within the synchronous DRAM. Self-refreshing is activated by setting both the
RMODE bit and the RFSH bit to 1. The self-refresh state is maintained while the CKE signal
is low. Synchronous DRAM cannot be accessed while in the self-refresh state. Self-refresh
mode is cleared by clearing the RMODE bit to 0. After self-refresh mode has been cleared,
command issuance is disabled for the number of cycles specified by the TPC bits in MCR.
Self-refresh timing is shown in figure 8.26. Settings must be made so that self-refresh clearing
and data retention are performed correctly, and auto-refreshing is performed at the correct
intervals. When self-refreshing is activated from the state in which auto-refreshing is set, or
when exiting standby mode other than through a power-on reset, auto-refreshing is restarted if
RFSH is set to 1 and RMODE is cleared to 0 when self-refresh mode is cleared. If the
transition from clearing of self-refresh mode to the start of auto-refreshing takes time, this time
should be taken into consideration when setting the initial value of RTCNT. Making the
RTCNT value 1 less than the RTCOR value will enable refreshing to be started immediately.
After self-refreshing has been set, the self-refresh state continues even if the chip standby state
is entered using the this LSI standby function, and is maintained even after recovery from
standby mode other than through a power-on reset. In case of a power-on reset, the bus state
controller's registers are initialized, and therefore the self-refresh state is cleared.
Self-refreshing is performed in normal operation, in sleep mode, in standby mode, and in case
of a manual reset.
CKIO
CKE
CSn
RASU,
RASL
CASU,
CASL
RD/WR
Figure 8.25 Synchronous DRAM Auto-Refresh Timing
Tp
TRr
TRrw
TRrw
(Tpc)