HD6417706F133 Renesas Electronics America, HD6417706F133 Datasheet - Page 447

• Manufacturer Part Number: HD6417706F133
• Description: IC SUPERH MPU ROMLESS 176LQFP
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7700r

Specifications of HD6417706F133

• Core Processor: SH-3
• Core Size: 32-Bit
• Speed: 133MHz
• Connectivity: EBI/EMI, FIFO, SCI, SmartCard
• Peripherals: DMA, POR, WDT
• Number Of I /o: 103
• Program Memory Type: ROMless
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 1.75 V ~ 2.05 V
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 176-LQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Program Memory Size: -
• Data Converters: -

In transmitting serial data, the SCI operates as follows:
1. The SCI monitors the TDRE bit in the SCSSR. When TDRE is cleared to 0, the SCI
2. After loading the data from the SCTDR into the SCTSR, the SCI sets the TDRE bit to 1 and
3. The SCI checks the TDRE bit when it outputs the stop bit. If TDRE is 0, the SCI loads new
Figure 14.9 shows an example of SCI transmit operation in the asynchronous mode.
recognizes that the transmit data register (SCTDR) contains new data, and loads this data from
the SCTDR into the SCTSR.
starts transmitting. If the transmit-data-empty interrupt enable bit (TIE) is set to 1 in the
SCSCR, the SCI requests a transmit-data-empty interrupt (TXI) at this time. Serial transmit
data is transmitted in the following order from the TxD0 pin:
a. Start bit: One 0 bit is output.
b. Transmit data: Seven or eight bits of data are output, LSB first.
c. Parity bit or multiprocessor bit: One parity bit (even or odd parity) or one multiprocessor
d. Stop bit: One or two 1 bits (stop bits) are output.
e. Marking: Output of 1 bits continues until the start bit of the next transmit data.
data from the SCTDR into the SCTSR, outputs the stop bit, then begins serial transmission of
the next frame. If TDRE is 1, the SCI sets the TEND bit to 1 in the SCSSR, outputs the stop
bit, then continues output of 1 bits (marking). If the transmit-end interrupt enable bit (TEIE) in
the SCSCR is set to 1, a transmit-end interrupt (TEI) is requested.
bit is output. Formats in which neither a parity bit nor a multiprocessor bit is output can
also be selected.
Section 14 Serial Communication Interface (SCI)
Rev. 5.00 May 29, 2006 page 397 of 698
REJ09B0146-0500