HD6417706F133 Renesas Electronics America, HD6417706F133 Datasheet - Page 615

• Manufacturer Part Number: HD6417706F133
• Description: IC SUPERH MPU ROMLESS 176LQFP
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7700r

Specifications of HD6417706F133

• Core Processor: SH-3
• Core Size: 32-Bit
• Speed: 133MHz
• Connectivity: EBI/EMI, FIFO, SCI, SmartCard
• Peripherals: DMA, POR, WDT
• Number Of I /o: 103
• Program Memory Type: ROMless
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 1.75 V ~ 2.05 V
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 176-LQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Program Memory Size: -
• Data Converters: -

Data loaded into the output pin boundary scan register in the Capture-DR state is not used for
external circuit testing (it is replaced by a shift operation).
The instruction code is 0000.
21.5.2
1. Boundary scan mode does not cover clock-related signals (EXTAL, EXTAL2, XTAL,
2. Boundary scan mode does not cover reset-related signals (RESETP, RESETM, CA).
3. Boundary scan mode does not cover H-UDI-related signals (TCK, TDI, TDO, TMS, TRST).
4. When a boundary scan test is carried out, ensure that the CKIO clock operates constantly.
5. Fix the RESETP pin low.
6. Fix the CA pin high, and the ASEMD0 pin low.
21.6
1. An H-UDI command other than an H-UDI interrupt, once set, will not be modified as long as
2. Because chip operations are suspended in standby mode, H-UDI commands are not accepted.
3. The H-UDI is used for emulator connection. Therefore, H-UDI functions cannot be used when
21.7
The AUD is a function exclusively for use by an emulator. Refer to the User's Manual for the
relevant emulator for details of the AUD.
XTAL2, CKIO).
The CKIO frequency range is as follows:
Minimum: 1 MHz
Maximum: Maximum frequency for respective clock mode specified in the CPG section
Set pins MD[2:0] to the clock mode to be used.
After powering on, wait for the CKIO clock to stabilize before performing a boundary scan
test.
another command is not re-issued from the H-UDI. An H-UDI interrupt command, however,
will be changed to a bypass command once set.
However, the TAP controller remains in operation at this time.
using an emulator.
Notes for Boundary Scan
Usage Note
Advanced User Debugger (AUD)
Section 21 User Debugging Interface (H-UDI)
Rev. 5.00 May 29, 2006 page 565 of 698
REJ09B0146-0500