EP4SE530H40I3 Altera, EP4SE530H40I3 Datasheet - Page 78

• Manufacturer Part Number: EP4SE530H40I3
• Description: IC STRATIX IV FPGA 530K 1517HBGA
• Manufacturer: Altera
• Series: STRATIX® IV Er

Specifications of EP4SE530H40I3

• Number Of Logic Elements/cells: 531200
• Number Of Labs/clbs: 21248
• Total Ram Bits: 27376
• Number Of I /o: 976
• Voltage - Supply: 0.87 V ~ 0.93 V
• Mounting Type: Surface Mount
• Operating Temperature: -40°C ~ 100°C
• Package / Case: 1517-HBGA
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Number Of Gates: -

3–22
Stratix IV Device Handbook Volume 1
Power-Up Conditions and Memory Initialization
f
Figure 3–22
behavior for don’t care mode in M9K and M144K blocks.
Figure 3–22. M9K and M144K Blocks Mixed-Port Read-During Write: Don’t Care Mode
Mixed-port read-during-write is not supported when two different clocks are used in
a dual-port RAM. The output value is unknown during a dual-clock mixed-port
read-during-write operation.
M9K memory cells are initialized to all zeros through a default .mif file in the
Quartus II software. However, you may specify your own initialization of the
memory cells through a defined .mif file. M144K memory cells are not initialized and;
therefore, come up in an undefined state. This is to prevent the programming file from
being too large. Again, you may specify your own initialization of the memory cells
through a defined .mif file.
MLABs power up to zero if output registers are used and power up reading the
memory contents if output registers are not used. You must take this into
consideration when designing logic that might evaluate the initial power-up values of
the MLAB memory block. For Stratix IV devices, the Quartus II software initializes
the RAM cells to zero unless there is a .mif file specified.
As mentioned, all memory blocks support initialization using a .mif file. You can
create .mif files in the Quartus II software and specify their use with the RAM
MegaWizard Plug-In Manager when instantiating a memory in your design. Even if a
memory is pre-initialized (for example, using a .mif file), it still powers up with its
outputs cleared.
For more information about .mif files, refer to the
User Guide
q_b_(asyn)
address_a
address_b
clk_a&b
bytenna
data_a
wrena
rdenb
and the
shows a sample functional waveform of mixed-port read-during-write
Quartus II
AAAA
11
Handbook.
BBBB
Chapter 3: TriMatrix Embedded Memory Blocks in Stratix IV Devices
01
A0
A0
CCCC
XXXX (unknown data)
10
Internal Memory (RAM and ROM)
DDDD
February 2011 Altera Corporation
EEEE
11
A1
A1
Design Considerations
FFFF