EP4SE530H40I3 Altera, EP4SE530H40I3 Datasheet - Page 856

• Manufacturer Part Number: EP4SE530H40I3
• Description: IC STRATIX IV FPGA 530K 1517HBGA
• Manufacturer: Altera
• Series: STRATIX® IV Er

Specifications of EP4SE530H40I3

• Number Of Logic Elements/cells: 531200
• Number Of Labs/clbs: 21248
• Total Ram Bits: 27376
• Number Of I /o: 976
• Voltage - Supply: 0.87 V ~ 0.93 V
• Mounting Type: Surface Mount
• Operating Temperature: -40°C ~ 100°C
• Package / Case: 1517-HBGA
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Number Of Gates: -

5–10
Table 5–4. Highest Possible Logical Channel Address
Stratix IV Device Handbook Volume 2: Transceivers
ALTGX MegaWizard Plug-In
Manager Setting
What is the number of
channels? in the General
screen
What is the starting channel
number? in the Reconfig
screen
1
The highest logical channel address is assigned to the Receiver only channel in the
96
The highest possible logical channel address assigned to a transceiver channel in a
Stratix IV device is the same whether the channel is a regular transceiver channel or a
PMA-only channel.
Total Number of Channels Option in the ALTGX_RECONFIG Instance
You can connect every dynamic reconfiguration controller in a design to either a
single ALTGX instance or to multiple ALTGX instances. Depending on the number of
channels within each of these ALTGX instances, you must set the total number of
channels controlled by the dynamic reconfiguration controller in the
ALTGX_RECONFIG MegaWizard Plug-In Manager. Based on this information, the
reconfig_fromgxb and logical_channel_address input ports vary in width.
Use the following steps to determine the number of channels:
1. Determine the highest logical channel address among all the transceiver instances
2. Round the logical channel address value to the next higher multiple of four.
3. Use this value to set the What is the number of channels controlled by the
For more information, refer to
th
connected to the same dynamic reconfiguration controller. For more information,
refer to
reconfig controller? option.
ALTGX instance; therefore, the setting is 380.
96 ALTGX Instances
TX instance 48: 188
ALTGX instance 1
TX instance 1: 0
TX instance 2: 4
“Logical Channel Addressing” on page
48
.
.
.
.
.
.
Quartus II MegaWizard Plug-In Manager Interfaces to Support Dynamic Reconfiguration
“Example 1” on page
RX instance 48: 380
RX instance 1: 192
RX instance 2: 196
ALTGX instance 2
48
Chapter 5: Dynamic Reconfiguration in Stratix IV Devices
.
.
.
.
.
.
5–5.
5–94.
ALTGX_RECONFIG instance 1:
Controls all 96 ALTGX instances.
ALTGX_RECONFIG Instance
February 2011 Altera Corporation