R8A77800ANBGAV Renesas Electronics America, R8A77800ANBGAV Datasheet - Page 6

• Manufacturer Part Number: R8A77800ANBGAV
• Description: IC SUPERH MPU ROMLESS 449-BGA
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7780r

Specifications of R8A77800ANBGAV

• Core Processor: SH-4A
• Core Size: 32-Bit
• Speed: 400MHz
• Connectivity: Audio Codec, MMC, Serial Sound, SCI, SIO, SPI, SSI
• Peripherals: DMA, POR, WDT
• Number Of I /o: 75
• Program Memory Type: ROMless
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 1.15 V ~ 1.35 V
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 449-BGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -
• Data Converters: -

General Precautions on Handling of Product
1. Treatment of NC Pins
Note: Do not connect anything to the NC pins.
2. Treatment of Unused Input Pins
Note: Fix all unused input pins to high or low level.
3. Processing before Initialization
Note: When power is first supplied, the product's state is undefined.
4. Prohibition of Access to Undefined or Reserved Addresses
Note: Access to undefined or reserved addresses is prohibited.
5. Reading from/Writing Reserved Bit of Each Register
Note: Treat the reserved bit of register used in each module as follows except in cases where the
Rev.1.00 Dec. 13, 2005 Page iv of l
The NC (not connected) pins are either not connected to any of the internal circuitry or are
used as test pins or to reduce noise. If something is connected to the NC pins, the
operation of the LSI is not guaranteed.
Generally, the input pins of CMOS products are high-impedance input pins. If unused pins
are in their open states, intermediate levels are induced by noise in the vicinity, a pass-
through current flows internally, and a malfunction may occur.
The states of internal circuits are undefined until full power is supplied throughout the
chip and a low level is input on the reset pin. During the period where the states are
undefined, the register settings and the output state of each pin are also undefined. Design
your system so that it does not malfunction because of processing while it is in this
undefined state. For those products which have a reset function, reset the LSI immediately
after the power supply has been turned on.
The undefined or reserved addresses may be used to expand functions, or test registers
may have been be allocated to these addresses. Do not access these registers; the system's
operation is not guaranteed if they are accessed.
specifications for values which are read from or written to the bit are provided in the
description.
The bit is always read as 0. The write value should be 0 or one, which has been read
immediately before writing.
Writing the value, which has been read immediately before writing has the advantage of
preventing the bit from being affected on its extended function when the function is
assigned.