FW82801DBM S L6DN Intel, FW82801DBM S L6DN Datasheet - Page 352

• Manufacturer Part Number: FW82801DBM S L6DN
• Manufacturer: Intel

Specifications of FW82801DBM S L6DN

• Lead Free Status / RoHS Status: Not Compliant

LPC Interface Bridge Registers (D31:F0)
352
NOTE: Delivery Mode Encoding (Bits 10:8):
10:8
7:0
Bit
11
000 =Fixed. Deliver the signal on the INTR signal of all processor cores listed in the destination. Trigger
001 =Lowest Priority. Deliver the signal on the INTR signal of the processor core that is executing at the
010 =SMI (System Management Interrupt). Requires the interrupt to be programmed as edge triggered.
011 =Reserved
100 =NMI. Deliver the signal on the NMI signal of all processor cores listed in the destination. Vector
101 =INIT. Deliver the signal to all processor cores listed in the destination by asserting the INIT signal.
110 =Reserved
111 =ExtINT. Deliver the signal to the INTR signal of all processor cores listed in the destination as an
Destination Mode — R/W. This field determines the interpretation of the Destination field.
0 = Physical. Destination APIC ID is identified by bits [59:56].
1 = Logical. Destinations are identified by matching bit [63:56] with the Logical Destination in the
Delivery Mode — R/W. This field specifies how the APICs listed in the destination field should act
upon reception of this signal. Certain Delivery Modes will only operate as intended when used in
conjunction with a specific trigger mode. These encodings are listed in the note below:
Vector — R/W. This field contains the interrupt vector for this interrupt. Values range between 10h
and FEh.
Mode can be edge or level.
lowest priority among all the processors listed in the specified destination. Trigger Mode can be
edge or level.
The vector information is ignored but must be programmed to all zeroes for future compatibility.
Not supported
information is ignored. NMI is treated as an edge triggered interrupt even if it is programmed as
level triggered. For proper operation this redirection table entry must be programmed to edge
triggered. The NMI delivery mode does not set the RIRR bit. Once the interrupt is detected, it will
be sent over the APIC bus. If the redirection table is incorrectly set to level, the loop count will
continue counting through the redirection table addresses. Once the count for the NMI pin is
reached again, the interrupt will be sent over the APIC bus again. Not supported
All addressed local APICs will assume their INIT state. INIT is always treated as an edge
triggered interrupt even if programmed as level triggered. For proper operation this redirection
table entry must be programmed to edge triggered. The INIT delivery mode does not set the
RIRR bit. Once the interrupt is detected, it will be sent over the APIC bus. If the redirection table
is incorrectly set to level, the loop count will continue counting through the redirection table
addresses. Once the count for the INIT pin is reached again, the interrupt will be sent over the
APIC bus again. Not supported
interrupt that originated in an externally connected 8259A compatible interrupt controller. The
INTA cycle that corresponds to this ExtINT delivery will be routed to the external controller that is
expected to supply the vector. Requires the interrupt to be programmed as edge triggered.
Destination Format Register and Logical Destination Register in each Local APIC.
Description
Intel
®
82801DBM ICH4-M Datasheet