FW82801DBM S L6DN Intel, FW82801DBM S L6DN Datasheet - Page 482

• Manufacturer Part Number: FW82801DBM S L6DN
• Manufacturer: Intel

Specifications of FW82801DBM S L6DN

• Lead Free Status / RoHS Status: Not Compliant

SMBus Controller Registers (D31:F3)
13.2.6
13.2.7
13.2.8
482
HST_D1—Data 1 Register
Register Offset:
Default Value:
Host_BLOCK_DB—Host Block Data Byte Register
Register Offset:
Default Value:
PEC—Packet Error Check (PEC) Register
Register Offset:
Default Value:
Bit
7:0
Bit
7:0
7:0
Bit
DATA1 — R/W. This eight bit register is transmitted in the DATA1 field of the SMBus protocol during
the execution of any command.
Block Data (BDTA) — R/W. This is either a register, or a pointer into a 32-byte block array, depending
upon whether the E32B bit is set in the Auxiliary Control register. When the E32B bit is cleared, this is
a register containing a byte of data to be sent on a block write or read from on a block read, just as it
behaved on the ICH3.
When the E32B bit is set, reads and writes to this register are used to access the 32-byte block data
storage array. An internal index pointer is used to address the array, which is reset to 0 by reading the
HCTL register (offset 02h). The index pointer then increments automatically upon each access to this
register. The transfer of block data into (read) or out of (write) this storage array during an SMBus
transaction always starts at index address 0.
When the E2B bit is set, for writes, software will write up to 32-bytes to this register as part of the
setup for the command. After the Host Controller has sent the Address, Command, and Byte Count
fields, it will send the bytes in the SRAM pointed to by this register. After the byte count has been
exhausted, the controller will set the DONE_STS bit (see definition above).
When the E2B bit is cleared for writes, software will place a single byte in this register. After the host
controller has sent the address, command, and byte count fields, it will send the byte in this register. If
there is more data to send, software will write the next series of bytes to the SRAM pointed to by this
register and clear the DONE_STS bit. The controller will then send the next byte. During the time
between the last byte being transmitted to the next byte being transmitted, the controller will insert
wait-states on the interface.
When the E2B bit is set for reads, after receiving the byte count into the Data0 register, the first series
of data bytes go into the SRAM pointed to by this register. If the byte count has been exhausted or the
32-byte SRAM has been filled, the controller will generate an SMI# or interrupt (depending on
configuration) and set the DONE_STS bit. Software will then read the data. During the time between
when the last byte is read from the SRAM to when the DONE_STS bit is cleared, the controller will
insert wait-states on the interface.
PEC_DATA — R/W. This 8-bit register is written with the 8-bit CRC value that is used as the
SMBus PEC data prior to a write transaction. For read transactions, the PEC data is loaded from
the SMBus into this register and is then read by software. Software must ensure that the
INUSE_STS bit is properly maintained to avoid having this field over-written by a write transaction
following a read transaction.
06h
07h
08h
00h
00h
00h
Description
Description
Description
Attribute:
Size:
Attribute:
Size:
Attribute:
Size:
Intel
®
82801DBM ICH4-M Datasheet
R/W
8 bits
R/W
8 bits
R/W
8 bits