R5F2L3AAANFP#U1 Renesas Electronics America, R5F2L3AAANFP#U1 Datasheet - Page 294

• Manufacturer Part Number: R5F2L3AAANFP#U1
• Description: MCU FLASH 96+4KB 100LQFP
• Manufacturer: Renesas Electronics America
• Series: R8C/Lx/3AAr

Specifications of R5F2L3AAANFP#U1

• Core Processor: R8C
• Core Size: 16/32-Bit
• Speed: 20MHz
• Connectivity: I²C, LIN, SIO, SSU, UART/USART
• Peripherals: LCD, POR, PWM, Voltage Detect, WDT
• Number Of I /o: 88
• Program Memory Size: 96KB (96K x 8)
• Program Memory Type: FLASH
• Ram Size: 10K x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 5.5 V
• Data Converters: A/D 20x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 85°C
• Package / Case: 100-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

R8C/L35A Group, R8C/L36A Group, R8C/L38A Group, R8C/L3AA Group,
R8C/L35B Group, R8C/L36B Group, R8C/L38B Group, R8C/L3AB Group
REJ09B0441-0100 Rev.1.00
Page 257 of 802
19. Timer RC
Timer RC is a 16-bit timer with four I/O pins.
19.1
Table 19.1
The count source is f1, f2, f4, f8, f32, or TRCCLK input.
(Bits TCK2 to TCK0 in the TRCCR1 register are set to 000b to 101b.)
Timer RC uses f1 as its operating clock. Table 19.1 lists the Timer RC Operating Clocks.
Table 19.2 lists the Timer RC Pin Configuration. Figure 19.1 shows the Timer RC Block Diagram.
Timer RC supports the following three modes:
• Timer mode
The following two modes use the output compare function:
• PWM mode
• PWM2 mode
For the input capture function, the output compare function, and in PWM mode, settings may be selected
independently for each pin.
In PWM2 mode, waveforms are output based on a combination of the counter or the register.
- Input capture function
- Output compare function
Introduction
Timer RC Operating Clocks
Oct 30, 2009
A match between the values of a counter and a register is detected.
(Pin output can be changed at detection.)
Pulses of a given width are output continuously.
A one-shot waveform or PWM waveform is output following the trigger after the
wait time has elapsed.
The counter value is captured to a register, using an external signal as the trigger.
Condition
f1
Timer RC Operating Clock
19. Timer RC