UPD70F3740GC-UEU-AX Renesas Electronics America, UPD70F3740GC-UEU-AX Datasheet - Page 461

• Manufacturer Part Number: UPD70F3740GC-UEU-AX
• Description: MCU 32BIT V850ES/JX3 100-LQFP
• Manufacturer: Renesas Electronics America
• Series: V850ES/Jx3r

Specifications of UPD70F3740GC-UEU-AX

• Core Processor: RISC
• Core Size: 32-Bit
• Speed: 32MHz
• Connectivity: CSI, EBI/EMI, I²C, UART/USART
• Peripherals: DMA, LVD, PWM, WDT
• Number Of I /o: 84
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 40K x 8
• Voltage - Supply (vcc/vdd): 2.85 V ~ 3.6 V
• Data Converters: A/D 12x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

V850ES/JG3
14.4 Operation
14.4.1 Operation in normal mode
14.4.2 Operation in real-time output mode
triggers.
R01UH0015EJ0300 Rev.3.00
Sep 30, 2010
D/A conversion is performed using a write operation to the DA0CSn register as the trigger.
The setting method is described below.
<1> Set the DA0M.DA0MDn bit to 0 (normal mode).
<2> Set the analog voltage value to be output to the ANOn pin to the DA0CSn register.
<3> Set the DA0M.DA0CEn bit to 1 (D/A conversion enable).
<4> To perform subsequent D/A conversions, write to the DA0CSn register.
Remarks 1. For the alternate-function pin settings, see Table 4-15 Using Port Pin as Alternate-Function Pin.
D/A conversion is performed using the interrupt request signals (INTTP2CC0 and INTTP3CC0) of TMP2 and TMP3 as
The setting method is described below.
<1> Set the DA0M.DA0MDn bit to 1 (real-time output mode).
<2> Set the analog voltage value to be output to the ANOn pin to the DA0CSn register.
<3> Set the DA0M.DA0CEn bit to 1 (D/A conversion enable).
<4> Operate TMP2 and TMP3.
<5> D/A conversion starts when the INTTP2CC0 and INTTP3CC0 signals are generated.
<6> After that, the value set in DA0CSn register is output every time the INTTP2CC0 and INTTP3CC0 signals are
Remarks 1. The output values of the ANO0 and ANO1 pins up to <5> above are undefined.
Steps <1> and <2> above constitute the initial settings.
D/A conversion starts when this setting is performed.
The previous D/A conversion result is held until the next D/A conversion is performed.
Steps <1> to <3> above constitute the initial settings.
generated.
2. n = 0, 1
2. For the output values of the ANO0 and ANO1 pins in the HALT, IDLE1, IDLE2, and STOP modes, see
3. For the alternate-function pin settings, see Table 4-15 Using Port Pin as Alternate-Function Pin.
CHAPTER 21 STANDBY FUNCTION.
CHAPTER 14 D/A CONVERTER
Page 445 of 870