TMP92xy26AXBG Toshiba, TMP92xy26AXBG Datasheet - Page 52

• Manufacturer Part Number: TMP92xy26AXBG
• Manufacturer: Toshiba

Specifications of TMP92xy26AXBG

• Package: FPGA228
• Rom Types(m=mask,p=otp, F=flash,e=eeprom): Romless
• Rom Combinations: Romless
• Ram Combinations: 144/288
• Architecture: 32-bit CISC
• Usb/spi Channels: 1/1
• Uart/sio Channels: 2
• I2c/sio Bus Channels: 1
• (s)dram Controller: 1
• Adc 10-bit Channel: 6
• Da Converter: -
• Timer 8-bit Channel: 8
• Timer 16-bit Channel: 2
• Pwm 8-bit Channels: -
• Pwm 16-bit Channels: -
• Cs/wait Controller: 4
• Dual Clock: Y
• Number Of I/o Ports: 136
• Power Supply Voltage(v): 3.0 to 3.6

Boot
ROM
RAM
1st byte
2nd byte
3rd byte
6th byte
7th byte
8th byte
9th byte
10th byte
(n − 4)th byte
(n − 3)th byte
(n − 2)th byte
(n − 1)th byte
n’th byte
−
Byte Number to
to
to
Transfer
Note: The built-in PLL (clock multiplier) is not used regardless of the oscillation frequency.
(3) UART data transfer format
“Error code x 3” means that the error code is transmitted three times. For example, if the error code is 62H, the
TMP92CF26A transmits 62H three times. For error codes, see (4)-b).
Table 3.4.6 to Table 3.4.11 show the supported frequencies, data transfer format, baud
rate modification command, operation command, and version management
information, respectively.
Please also refer to the description of boot program operation later in this section.
Matching data (5AH)
−
−
−
Baud rate modification command
−
User program
Intel Hex format (binary)
−
−
User program start command (C0H)
(See Table 3.4.9.)
−
Branch to user program start address
(See Table 3.4.8.)
Transfer data from PC to TMP92CF26A
6.00 MHz
Table 3.4.6 Supported Frequencies (X1)
Table 3.4.7 Transfer Format
8.00 MHz
92CF26A-50
9600 bps
9.00 MHz
New baud rate
Baud Rate
− (Frequency measurement and baud
rate auto setting)
OK: Echo back data (5AH)
Error: No transfer
Version management information
(See Table 3.4.10)
Frequency information
−
OK: Echo back data
Error: Error code x 3
NG: Operation stop by checksum error
OK: SUM (High)
(See (4)-c).)
OK: SUM (Low)
−
OK: Echo back data (C0H)
Error: Error code x 3
10.00 MHz
Transfer data from TMP92CF26A to PC
TMP92CF26A
2009-06-25