MCBSTM32EXL Keil, MCBSTM32EXL Datasheet - Page 301

• Manufacturer Part Number: MCBSTM32EXL
• Description: BOARD EVALUATION FOR STM32F103ZE
• Manufacturer: Keil

Specifications of MCBSTM32EXL

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

RM0008
13.4.5
15
Reserved
14
Bit 15:13 Reserved, always read as 0.
TIM1&TIM8 status register (TIMx_SR)
Address offset: 0x10
Reset value: 0x0000
Bit 12 CC4OF: Capture/Compare 4 overcapture flag
Bit 11 CC3OF: Capture/Compare 3 overcapture flag
Bit 10 CC2OF: Capture/Compare 2 overcapture flag
Bit 9 CC1OF: Capture/Compare 1 overcapture flag
Bit 8 Reserved, always read as 0.
Bit 7 BIF: Break interrupt flag
Bit 6 TIF: Trigger interrupt flag
Bit 5 COMIF: COM interrupt flag
Bit 4 CC4IF: Capture/Compare 4 interrupt flag
Bit 3 CC3IF: Capture/Compare 3 interrupt flag
13
CC4OF CC3OF CC2OF CC1OF
rc_w0
refer to CC1OF description
refer to CC1OF description
refer to CC1OF description
This flag is set by hardware only when the corresponding channel is configured in input
capture mode. It is cleared by software by writing it to ‘0’.
0: No overcapture has been detected.
1: The counter value has been captured in TIMx_CCR1 register while CC1IF flag was
already set
This flag is set by hardware as soon as the break input goes active. It can be cleared by
software if the break input is not active.
0: No break event occurred.
1: An active level has been detected on the break input.
This flag is set by hardware on trigger event (active edge detected on TRGI input when the
slave mode controller is enabled in all modes but gated mode, both edges in case gated
mode is selected). It is cleared by software.
0: No trigger event occurred.
1: Trigger interrupt pending.
This flag is set by hardware on COM event (when Capture/compare Control bits - CCxE,
CCxNE, OCxM - have been updated). It is cleared by software.
0: No COM event occurred.
1: COM interrupt pending.
refer to CC1IF description
refer to CC1IF description
12
rc_w0
11
rc_w0
10
rc_w0
9
Doc ID 13902 Rev 9
Res.
Res.
8
rc_w0
BIF
7
rc_w0
TIF
6
Advanced-control timers (TIM1&TIM8)
COMIF
rc_w0
5
CC4IF
rc_w0
4
CC3IF
rc_w0
3
CC2IF
rc_w0
2
CC1IF
rc_w0
1
301/995
rc_w0
UIF
0