MCBSTM32EXL Keil, MCBSTM32EXL Datasheet - Page 810

• Manufacturer Part Number: MCBSTM32EXL
• Description: BOARD EVALUATION FOR STM32F103ZE
• Manufacturer: Keil

Specifications of MCBSTM32EXL

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

USB on-the-go full-speed (OTG_FS)
26.15.5
810/995
●
Device programming model
Endpoint initialization on USB reset
1.
2.
3.
4.
At this point, all initialization required to receive SETUP packets is done.
periodic request queue depth is smaller than the periodic transfers scheduled in a
microframe, a frame overrun condition occurs.
Handling babble conditions
OTG_FS controller handles two cases of babble: packet babble and port babble.
Packet babble occurs if the device sends more data than the maximum packet size for
the channel. Port babble occurs if the core continues to receive data from the device at
EOF2 (the end of frame 2, which is very close to SOF).
When OTG_FS controller detects a packet babble, it stops writing data into the Rx
buffer and waits for the end of packet (EOP). When it detects an EOP, it flushes already
written data in the Rx buffer and generates a Babble interrupt to the application.
When OTG_FS controller detects a port babble, it flushes the RxFIFO and disables the
port. The core then generates a Port disabled interrupt (HPRTINT in
OTG_FS_GINTSTS, PENCHNG in OTG_FS_HPRT). On receiving this interrupt, the
application must determine that this is not due to an overcurrent condition (another
cause of the Port Disabled interrupt) by checking POCA in OTG_FS_HPRT, then
perform a soft reset. The core does not send any more tokens after it has detected a
port babble condition.
Set the NAK bit for all OUT endpoints
–
Unmask the following interrupt bits
–
–
–
–
–
–
Set up the Data FIFO RAM for each of the FIFOs
–
–
Program the following fields in the endpoint-specific registers for control OUT endpoint
0 to receive a SETUP packet
–
SNAK = 1 in OTG_FS_DOEPCTLx (for all OUT endpoints)
INEP0 = 1 in OTG_FS_DAINTMSK (control 0 IN endpoint)
OUTEP0 = 1 in OTG_FS_DAINTMSK (control 0 OUT endpoint)
STUP = 1 in DOEPMSK
XFRC = 1 in DOEPMSK
XFRC = 1 in DIEPMSK
TOC = 1 in DIEPMSK
Program the OTG_FS_GRXFSIZ register, to be able to receive control OUT data
and setup data. If thresholding is not enabled, at a minimum, this must be equal to
1 max packet size of control endpoint 0 + 2 DWORDs (for the status of the control
OUT data packet) + 10 DWORDs (for setup packets).
Program the OTG_FS_GNPTXFSIZ register (depending on the FIFO number
chosen) to be able to transmit control IN data. At a minimum, this must be equal to
1 max packet size of control endpoint 0.
STUPCNT = 3 in OTG_FS_DOEPTSIZ0 (to receive up to 3 back-to-back SETUP
packets)
Doc ID 13902 Rev 9
RM0008